Move the GPIO mux configuration needed for camera module to work to the
GPIO node instead of the I2C node.
Camera nodes are maintained as overlay files, but the common mux is
always needed to ensure that camera probes fine and ensuring the mux
is configured as part of the GPIO module allows for the multiple
overlay files to be simpler.
Cc: Robert Nelson <[email protected]>
Suggested-by: Udit Kumar <[email protected]>
Signed-off-by: Nishanth Menon <[email protected]>
---
New patch
arch/arm64/boot/dts/ti/k3-j721e-beagleboneai64.dts | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-beagleboneai64.dts b/arch/arm64/boot/dts/ti/k3-j721e-beagleboneai64.dts
index 37c24b077b6a..1a65d3617a29 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-beagleboneai64.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721e-beagleboneai64.dts
@@ -593,7 +593,7 @@ &main_i2c0 {
&main_i2c1 {
status = "okay";
pinctrl-names = "default";
- pinctrl-0 = <&main_i2c1_pins_default &csi1_gpio_pins_default>;
+ pinctrl-0 = <&main_i2c1_pins_default>;
clock-frequency = <400000>;
};
@@ -623,7 +623,7 @@ &main_i2c4 {
&main_i2c5 {
status = "okay";
pinctrl-names = "default";
- pinctrl-0 = <&main_i2c5_pins_default &csi0_gpio_pins_default>;
+ pinctrl-0 = <&main_i2c5_pins_default>;
clock-frequency = <400000>;
};
@@ -688,6 +688,11 @@ &wkup_gpio1 {
status = "disabled";
};
+&main_gpio0 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&csi1_gpio_pins_default>, <&csi0_gpio_pins_default>;
+};
+
&usb_serdes_mux {
idle-states = <1>, <1>; /* USB0 to SERDES3, USB1 to SERDES2 */
};
--
2.40.0