The DSI to HDMI bridge uses the address currently assigned to
the camera, so change the camera address to the alternative
address of 0x10 in preparation to enable the bridge.
Signed-off-by: Adam Ford <[email protected]>
diff --git a/arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi
index bc531175ff76..d5c6fc68d656 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mm-beacon-baseboard.dtsi
@@ -141,11 +141,11 @@ &i2c2 {
pinctrl-0 = <&pinctrl_i2c2>;
status = "okay";
- camera@3c {
+ camera@10 {
compatible = "ovti,ov5640";
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_ov5640>;
- reg = <0x3c>;
+ reg = <0x10>;
clocks = <&clk IMX8MM_CLK_CLKO1>;
clock-names = "xclk";
assigned-clocks = <&clk IMX8MM_CLK_CLKO1>;
--
2.39.2