The kexec and crash kernel options are provided in the common
kernel/Kconfig.kexec. Utilize the common options and provide
the ARCH_SUPPORTS_ and ARCH_SELECTS_ entries to recreate the
equivalent set of KEXEC and CRASH options.
Signed-off-by: Eric DeVolder <[email protected]>
Acked-by: Thomas Bogendoerfer <[email protected]>
---
arch/mips/Kconfig | 32 +++++---------------------------
1 file changed, 5 insertions(+), 27 deletions(-)
diff --git a/arch/mips/Kconfig b/arch/mips/Kconfig
index 675a8660cb85..3d9960942cbd 100644
--- a/arch/mips/Kconfig
+++ b/arch/mips/Kconfig
@@ -2873,33 +2873,11 @@ config HZ
config SCHED_HRTICK
def_bool HIGH_RES_TIMERS
-config KEXEC
- bool "Kexec system call"
- select KEXEC_CORE
- help
- kexec is a system call that implements the ability to shutdown your
- current kernel, and to start another kernel. It is like a reboot
- but it is independent of the system firmware. And like a reboot
- you can start any kernel with it, not just Linux.
-
- The name comes from the similarity to the exec system call.
-
- It is an ongoing process to be certain the hardware in a machine
- is properly shutdown, so do not be surprised if this code does not
- initially work for you. As of this writing the exact hardware
- interface is strongly in flux, so no good recommendation can be
- made.
-
-config CRASH_DUMP
- bool "Kernel crash dumps"
- help
- Generate crash dump after being started by kexec.
- This should be normally only set in special crash dump kernels
- which are loaded in the main kernel with kexec-tools into
- a specially reserved region and then later executed after
- a crash by kdump/kexec. The crash dump kernel must be compiled
- to a memory address not used by the main kernel or firmware using
- PHYSICAL_START.
+config ARCH_SUPPORTS_KEXEC
+ def_bool y
+
+config ARCH_SUPPORTS_CRASH_DUMP
+ def_bool y
config PHYSICAL_START
hex "Physical address where the kernel is loaded"
--
2.31.1