In the schematics of document UM1907, the power supply for the micro SD
card is the same 3v3 voltage that is used to power other devices on the
board. By generalizing the name of the voltage regulator, it can be
referenced by other nodes in the device tree without creating
misunderstandings.
This patch is preparatory for future developments.
Signed-off-by: Dario Binacchi <[email protected]>
---
(no changes since v1)
arch/arm/boot/dts/st/stm32f746-disco.dts | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/arch/arm/boot/dts/st/stm32f746-disco.dts b/arch/arm/boot/dts/st/stm32f746-disco.dts
index c11616ed5fc6..4e785039ba5a 100644
--- a/arch/arm/boot/dts/st/stm32f746-disco.dts
+++ b/arch/arm/boot/dts/st/stm32f746-disco.dts
@@ -79,9 +79,9 @@ vcc5v_otg_fs: vcc5v-otg-fs-regulator {
regulator-always-on;
};
- mmc_vcard: mmc_vcard {
+ vcc_3v3: vcc-3v3 {
compatible = "regulator-fixed";
- regulator-name = "mmc_vcard";
+ regulator-name = "vcc_3v3";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
};
@@ -101,7 +101,7 @@ &i2c1 {
&sdio1 {
status = "okay";
- vmmc-supply = <&mmc_vcard>;
+ vmmc-supply = <&vcc_3v3>;
cd-gpios = <&gpioc 13 GPIO_ACTIVE_LOW>;
pinctrl-names = "default", "opendrain";
pinctrl-0 = <&sdio_pins_a>;
--
2.34.1