On Mon, 04 Sep 2023 14:44:41 +0900, Inki Dae wrote:
> 2023년 8월 29일 (화) 오전 12:59, Michael Tretter <[email protected]>님이 작성:
> >
> > The PLL requires a clock between 2 MHz and 30 MHz after the pre-divider.
> > The reference clock for the PLL may change due to changes to it's parent
> > clock. Thus, the frequency may be out of range or unsuited for
> > generating the high speed clock for MIPI DSI.
> >
> > Try to keep the pre-devider small, and set the reference clock close to
> > 30 MHz before recalculating the PLL configuration. Use a divider with a
> > power of two for the reference clock as this seems to work best in
> > my tests.
>
> Clock frequency is specific to SoC architecture so we have to handle
> it carefully because samsung-dsim.c is a common module for I.MX and
> Exynos series.
> You mentioned "The PLL requires a clock between 2 MHz and 3MHz after
> pre-divider", and the clock means that fin_pll - PFD input frequency -
> which can be calculated with oscillator clock frequency / P value?
> According to Exynos datasheet, the fin_pll should be 6 ~ 12Mhz.
>
> For example,
> In case of Exyhos, we use 24MHz as oscillator clock frequency, so
> fin_pll frequency, 8MHz = 24MHz / P(3).
>
> Can you tell me the source of the constraint that clocks must be
> between 2MHz and 30MHz?
The source is the i.MX8M Nano reference manual, Table 13-40. DPHY PLL
Parameters. It documents that the P divider frequency (fin_pll) has a
frequency range of 2 MHz to 30 MHz. According to the same table, the input
frequency (fin) has a range of 6 MHz to 300 MHz.
Is the table incorrect?
I also tried to always set the reference clock to 24 MHz, but depending on the
display clock this isn't always possible.
Michael
>
> To other I.MX and Exynos engineers, please do not merge this patch
> until two SoC platforms are tested correctly.
>
> Thanks,
> Inki Dae
>
> >
> > Signed-off-by: Michael Tretter <[email protected]>
> > ---
> > drivers/gpu/drm/bridge/samsung-dsim.c | 15 +++++++++++++--
> > 1 file changed, 13 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/bridge/samsung-dsim.c b/drivers/gpu/drm/bridge/samsung-dsim.c
> > index da90c2038042..4de6e4f116db 100644
> > --- a/drivers/gpu/drm/bridge/samsung-dsim.c
> > +++ b/drivers/gpu/drm/bridge/samsung-dsim.c
> > @@ -611,10 +611,21 @@ static unsigned long samsung_dsim_set_pll(struct samsung_dsim *dsi,
> > u16 m;
> > u32 reg;
> >
> > - if (dsi->pll_clk)
> > + if (dsi->pll_clk) {
> > + /*
> > + * Ensure that the reference clock is generated with a power of
> > + * two divider from its parent, but close to the PLLs upper
> > + * limit of the valid range of 2 MHz to 30 MHz.
> > + */
> > + fin = clk_get_rate(clk_get_parent(dsi->pll_clk));
> > + while (fin > 30 * MHZ)
> > + fin = fin / 2;
> > + clk_set_rate(dsi->pll_clk, fin);
> > +
> > fin = clk_get_rate(dsi->pll_clk);
> > - else
> > + } else {
> > fin = dsi->pll_clk_rate;
> > + }
> > dev_dbg(dsi->dev, "PLL ref clock freq %lu\n", fin);
> >
> > fout = samsung_dsim_pll_find_pms(dsi, fin, freq, &p, &m, &s);
> >
> > --
> > 2.39.2
> >
>