This patch adds support for half duplex operation at 10M and 100M link
speeds for AM654x/AM64x devices.
- Driver configures rand_seed, a random number, in DMEM HD_RAND_SEED_OFFSET
field, which will be used by firmware for Back off time calculation.
- Driver informs FW about half duplex link operation in DMEM
PORT_LINK_SPEED_OFFSET field by setting bit 7 for 10/100M HD.
Hence, the half duplex operation depends on board design the
"ti,half-duplex-capable" property has to be enabled for ICSS-G ports if HW
is capable to perform half duplex.
Reviewed-by: Andrew Lunn <[email protected]>
Reviewed-by: Roger Quadros <[email protected]>
Signed-off-by: MD Danish Anwar <[email protected]>
---
drivers/net/ethernet/ti/icssg/icssg_config.c | 14 ++++++++++++++
drivers/net/ethernet/ti/icssg/icssg_prueth.c | 17 +++++++++++++++--
drivers/net/ethernet/ti/icssg/icssg_prueth.h | 2 ++
3 files changed, 31 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/ti/icssg/icssg_config.c b/drivers/net/ethernet/ti/icssg/icssg_config.c
index 933b84666574..c1da70f247d4 100644
--- a/drivers/net/ethernet/ti/icssg/icssg_config.c
+++ b/drivers/net/ethernet/ti/icssg/icssg_config.c
@@ -433,6 +433,17 @@ int emac_set_port_state(struct prueth_emac *emac,
return ret;
}
+void icssg_config_half_duplex(struct prueth_emac *emac)
+{
+ u32 val;
+
+ if (!emac->half_duplex)
+ return;
+
+ val = get_random_u32();
+ writel(val, emac->dram.va + HD_RAND_SEED_OFFSET);
+}
+
void icssg_config_set_speed(struct prueth_emac *emac)
{
u8 fw_speed;
@@ -453,5 +464,8 @@ void icssg_config_set_speed(struct prueth_emac *emac)
return;
}
+ if (emac->duplex == DUPLEX_HALF)
+ fw_speed |= FW_LINK_SPEED_HD;
+
writeb(fw_speed, emac->dram.va + PORT_LINK_SPEED_OFFSET);
}
diff --git a/drivers/net/ethernet/ti/icssg/icssg_prueth.c b/drivers/net/ethernet/ti/icssg/icssg_prueth.c
index 92b13057d4de..6635b28bc672 100644
--- a/drivers/net/ethernet/ti/icssg/icssg_prueth.c
+++ b/drivers/net/ethernet/ti/icssg/icssg_prueth.c
@@ -1029,6 +1029,8 @@ static void emac_adjust_link(struct net_device *ndev)
* values
*/
if (emac->link) {
+ if (emac->duplex == DUPLEX_HALF)
+ icssg_config_half_duplex(emac);
/* Set the RGMII cfg for gig en and full duplex */
icssg_update_rgmii_cfg(prueth->miig_rt, emac);
@@ -1147,9 +1149,13 @@ static int emac_phy_connect(struct prueth_emac *emac)
return -ENODEV;
}
+ if (!emac->half_duplex) {
+ dev_dbg(prueth->dev, "half duplex mode is not supported\n");
+ phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_10baseT_Half_BIT);
+ phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_100baseT_Half_BIT);
+ }
+
/* remove unsupported modes */
- phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_10baseT_Half_BIT);
- phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_100baseT_Half_BIT);
phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_1000baseT_Half_BIT);
phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_Pause_BIT);
phy_remove_link_mode(ndev->phydev, ETHTOOL_LINK_MODE_Asym_Pause_BIT);
@@ -2113,6 +2119,10 @@ static int prueth_probe(struct platform_device *pdev)
eth0_node->name);
goto exit_iep;
}
+
+ if (of_find_property(eth0_node, "ti,half-duplex-capable", NULL))
+ prueth->emac[PRUETH_MAC0]->half_duplex = 1;
+
prueth->emac[PRUETH_MAC0]->iep = prueth->iep0;
}
@@ -2124,6 +2134,9 @@ static int prueth_probe(struct platform_device *pdev)
goto netdev_exit;
}
+ if (of_find_property(eth1_node, "ti,half-duplex-capable", NULL))
+ prueth->emac[PRUETH_MAC1]->half_duplex = 1;
+
prueth->emac[PRUETH_MAC1]->iep = prueth->iep0;
}
diff --git a/drivers/net/ethernet/ti/icssg/icssg_prueth.h b/drivers/net/ethernet/ti/icssg/icssg_prueth.h
index 3fe80a8758d3..8b6d6b497010 100644
--- a/drivers/net/ethernet/ti/icssg/icssg_prueth.h
+++ b/drivers/net/ethernet/ti/icssg/icssg_prueth.h
@@ -145,6 +145,7 @@ struct prueth_emac {
struct icss_iep *iep;
unsigned int rx_ts_enabled : 1;
unsigned int tx_ts_enabled : 1;
+ unsigned int half_duplex : 1;
/* DMA related */
struct prueth_tx_chn tx_chns[PRUETH_MAX_TX_QUEUES];
@@ -271,6 +272,7 @@ int icssg_config(struct prueth *prueth, struct prueth_emac *emac,
int emac_set_port_state(struct prueth_emac *emac,
enum icssg_port_state_cmd state);
void icssg_config_set_speed(struct prueth_emac *emac);
+void icssg_config_half_duplex(struct prueth_emac *emac);
/* Buffer queue helpers */
int icssg_queue_pop(struct prueth *prueth, u8 queue);
--
2.34.1