From: Thomas Gleixner <[email protected]>
When a serial port is used for kernel console output, then all
modifications to the UART registers which are done from other contexts,
e.g. getty, termios, are interference points for the kernel console.
So far this has been ignored and the printk output is based on the
principle of hope. The rework of the console infrastructure which aims to
support threaded and atomic consoles, requires to mark sections which
modify the UART registers as unsafe. This allows the atomic write function
to make informed decisions and eventually to restore operational state. It
also allows to prevent the regular UART code from modifying UART registers
while printk output is in progress.
All modifications of UART registers are guarded by the UART port lock,
which provides an obvious synchronization point with the console
infrastructure.
To avoid adding this functionality to all UART drivers, wrap the
spin_[un]lock*() invocations for uart_port::lock into helper functions
which just contain the spin_[un]lock*() invocations for now. In a
subsequent step these helpers will gain the console synchronization
mechanisms.
Converted with coccinelle. No functional change.
Signed-off-by: Thomas Gleixner <[email protected]>
---
drivers/tty/serial/sb1250-duart.c | 12 ++++++------
1 file changed, 6 insertions(+), 6 deletions(-)
diff --git a/drivers/tty/serial/sb1250-duart.c b/drivers/tty/serial/sb1250-duart.c
index f3cd69346482..dbec29d9a6c3 100644
--- a/drivers/tty/serial/sb1250-duart.c
+++ b/drivers/tty/serial/sb1250-duart.c
@@ -610,7 +610,7 @@ static void sbd_set_termios(struct uart_port *uport, struct ktermios *termios,
else
aux &= ~M_DUART_CTS_CHNG_ENA;
- spin_lock(&uport->lock);
+ uart_port_lock(uport);
if (sport->tx_stopped)
command |= M_DUART_TX_DIS;
@@ -632,7 +632,7 @@ static void sbd_set_termios(struct uart_port *uport, struct ktermios *termios,
write_sbdchn(sport, R_DUART_CMD, command);
- spin_unlock(&uport->lock);
+ uart_port_unlock(uport);
}
@@ -839,22 +839,22 @@ static void sbd_console_write(struct console *co, const char *s,
unsigned int mask;
/* Disable transmit interrupts and enable the transmitter. */
- spin_lock_irqsave(&uport->lock, flags);
+ uart_port_lock_irqsave(uport, &flags);
mask = read_sbdshr(sport, R_DUART_IMRREG((uport->line) % 2));
write_sbdshr(sport, R_DUART_IMRREG((uport->line) % 2),
mask & ~M_DUART_IMR_TX);
write_sbdchn(sport, R_DUART_CMD, M_DUART_TX_EN);
- spin_unlock_irqrestore(&uport->lock, flags);
+ uart_port_unlock_irqrestore(uport, flags);
uart_console_write(&sport->port, s, count, sbd_console_putchar);
/* Restore transmit interrupts and the transmitter enable. */
- spin_lock_irqsave(&uport->lock, flags);
+ uart_port_lock_irqsave(uport, &flags);
sbd_line_drain(sport);
if (sport->tx_stopped)
write_sbdchn(sport, R_DUART_CMD, M_DUART_TX_DIS);
write_sbdshr(sport, R_DUART_IMRREG((uport->line) % 2), mask);
- spin_unlock_irqrestore(&uport->lock, flags);
+ uart_port_unlock_irqrestore(uport, flags);
}
static int __init sbd_console_setup(struct console *co, char *options)
--
2.39.2