From: Thomas Gleixner <[email protected]>
When a serial port is used for kernel console output, then all
modifications to the UART registers which are done from other contexts,
e.g. getty, termios, are interference points for the kernel console.
So far this has been ignored and the printk output is based on the
principle of hope. The rework of the console infrastructure which aims to
support threaded and atomic consoles, requires to mark sections which
modify the UART registers as unsafe. This allows the atomic write function
to make informed decisions and eventually to restore operational state. It
also allows to prevent the regular UART code from modifying UART registers
while printk output is in progress.
All modifications of UART registers are guarded by the UART port lock,
which provides an obvious synchronization point with the console
infrastructure.
To avoid adding this functionality to all UART drivers, wrap the
spin_[un]lock*() invocations for uart_port::lock into helper functions
which just contain the spin_[un]lock*() invocations for now. In a
subsequent step these helpers will gain the console synchronization
mechanisms.
Converted with coccinelle. No functional change.
Signed-off-by: Thomas Gleixner <[email protected]>
---
drivers/tty/serial/uartlite.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)
diff --git a/drivers/tty/serial/uartlite.c b/drivers/tty/serial/uartlite.c
index b225a78f6175..404c14acafa5 100644
--- a/drivers/tty/serial/uartlite.c
+++ b/drivers/tty/serial/uartlite.c
@@ -216,11 +216,11 @@ static irqreturn_t ulite_isr(int irq, void *dev_id)
unsigned long flags;
do {
- spin_lock_irqsave(&port->lock, flags);
+ uart_port_lock_irqsave(port, &flags);
stat = uart_in32(ULITE_STATUS, port);
busy = ulite_receive(port, stat);
busy |= ulite_transmit(port, stat);
- spin_unlock_irqrestore(&port->lock, flags);
+ uart_port_unlock_irqrestore(port, flags);
n++;
} while (busy);
@@ -238,9 +238,9 @@ static unsigned int ulite_tx_empty(struct uart_port *port)
unsigned long flags;
unsigned int ret;
- spin_lock_irqsave(&port->lock, flags);
+ uart_port_lock_irqsave(port, &flags);
ret = uart_in32(ULITE_STATUS, port);
- spin_unlock_irqrestore(&port->lock, flags);
+ uart_port_unlock_irqrestore(port, flags);
return ret & ULITE_STATUS_TXEMPTY ? TIOCSER_TEMT : 0;
}
@@ -323,7 +323,7 @@ static void ulite_set_termios(struct uart_port *port,
termios->c_cflag |= pdata->cflags & (PARENB | PARODD | CSIZE);
tty_termios_encode_baud_rate(termios, pdata->baud, pdata->baud);
- spin_lock_irqsave(&port->lock, flags);
+ uart_port_lock_irqsave(port, &flags);
port->read_status_mask = ULITE_STATUS_RXVALID | ULITE_STATUS_OVERRUN
| ULITE_STATUS_TXFULL;
@@ -346,7 +346,7 @@ static void ulite_set_termios(struct uart_port *port,
/* update timeout */
uart_update_timeout(port, termios->c_cflag, pdata->baud);
- spin_unlock_irqrestore(&port->lock, flags);
+ uart_port_unlock_irqrestore(port, flags);
}
static const char *ulite_type(struct uart_port *port)
@@ -495,9 +495,9 @@ static void ulite_console_write(struct console *co, const char *s,
int locked = 1;
if (oops_in_progress) {
- locked = spin_trylock_irqsave(&port->lock, flags);
+ locked = uart_port_trylock_irqsave(port, &flags);
} else
- spin_lock_irqsave(&port->lock, flags);
+ uart_port_lock_irqsave(port, &flags);
/* save and disable interrupt */
ier = uart_in32(ULITE_STATUS, port) & ULITE_STATUS_IE;
@@ -512,7 +512,7 @@ static void ulite_console_write(struct console *co, const char *s,
uart_out32(ULITE_CONTROL_IE, ULITE_CONTROL, port);
if (locked)
- spin_unlock_irqrestore(&port->lock, flags);
+ uart_port_unlock_irqrestore(port, flags);
}
static int ulite_console_setup(struct console *co, char *options)
--
2.39.2