From: David Regan <[email protected]>
Pass host struct to bcmnand_ctrl_poll_status instead of ctrl struct
since real time status requires host, and ctrl is a member of host.
Real time status is required for low level commands vs cached status
since the NAND controller will not do an automatic status read at the
end of a low level command as it would with a high level command.
Signed-off-by: David Regan <[email protected]>
---
Changes in v5: none
Changes in v4: none
Changes in v3: none
Changes in v2: added this patch in series
---
drivers/mtd/nand/raw/brcmnand/brcmnand.c | 13 +++++++------
1 file changed, 7 insertions(+), 6 deletions(-)
diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.c b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
index 440bef477930..8d429eb3b72a 100644
--- a/drivers/mtd/nand/raw/brcmnand/brcmnand.c
+++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
@@ -1061,10 +1061,11 @@ enum {
CS_SELECT_AUTO_DEVICE_ID_CFG = BIT(30),
};
-static int bcmnand_ctrl_poll_status(struct brcmnand_controller *ctrl,
+static int bcmnand_ctrl_poll_status(struct brcmnand_host *host,
u32 mask, u32 expected_val,
unsigned long timeout_ms)
{
+ struct brcmnand_controller *ctrl = host->ctrl;
unsigned long limit;
u32 val;
@@ -1379,7 +1380,7 @@ static void brcmnand_wp(struct mtd_info *mtd, int wp)
* make sure ctrl/flash ready before and after
* changing state of #WP pin
*/
- ret = bcmnand_ctrl_poll_status(ctrl, NAND_CTRL_RDY |
+ ret = bcmnand_ctrl_poll_status(host, NAND_CTRL_RDY |
NAND_STATUS_READY,
NAND_CTRL_RDY |
NAND_STATUS_READY, 0);
@@ -1389,7 +1390,7 @@ static void brcmnand_wp(struct mtd_info *mtd, int wp)
brcmnand_set_wp(ctrl, wp);
nand_status_op(chip, NULL);
/* NAND_STATUS_WP 0x00 = protected, 0x80 = not protected */
- ret = bcmnand_ctrl_poll_status(ctrl,
+ ret = bcmnand_ctrl_poll_status(host,
NAND_CTRL_RDY |
NAND_STATUS_READY |
NAND_STATUS_WP,
@@ -1629,13 +1630,13 @@ static void brcmnand_send_cmd(struct brcmnand_host *host, int cmd)
*/
if (oops_in_progress) {
if (ctrl->cmd_pending &&
- bcmnand_ctrl_poll_status(ctrl, NAND_CTRL_RDY, NAND_CTRL_RDY, 0))
+ bcmnand_ctrl_poll_status(host, NAND_CTRL_RDY, NAND_CTRL_RDY, 0))
return;
} else
BUG_ON(ctrl->cmd_pending != 0);
ctrl->cmd_pending = cmd;
- ret = bcmnand_ctrl_poll_status(ctrl, NAND_CTRL_RDY, NAND_CTRL_RDY, 0);
+ ret = bcmnand_ctrl_poll_status(host, NAND_CTRL_RDY, NAND_CTRL_RDY, 0);
WARN_ON(ret);
mb(); /* flush previous writes */
@@ -1664,7 +1665,7 @@ static bool brcmstb_nand_wait_for_completion(struct nand_chip *chip)
if (mtd->oops_panic_write || ctrl->irq < 0) {
/* switch to interrupt polling and PIO mode */
disable_ctrl_irqs(ctrl);
- sts = bcmnand_ctrl_poll_status(ctrl, NAND_CTRL_RDY,
+ sts = bcmnand_ctrl_poll_status(host, NAND_CTRL_RDY,
NAND_CTRL_RDY, 0);
err = sts < 0;
} else {
--
2.37.3
On 11/24/2023 5:24 PM, [email protected] wrote:
> From: David Regan <[email protected]>
>
> Pass host struct to bcmnand_ctrl_poll_status instead of ctrl struct
> since real time status requires host, and ctrl is a member of host.
> Real time status is required for low level commands vs cached status
> since the NAND controller will not do an automatic status read at the
> end of a low level command as it would with a high level command.
>
> Signed-off-by: David Regan <[email protected]>
Reviewed-by: Florian Fainelli <[email protected]>
--
Florian
On Sat, 2023-11-25 at 01:24:37 UTC, [email protected] wrote:
> From: David Regan <[email protected]>
>
> Pass host struct to bcmnand_ctrl_poll_status instead of ctrl struct
> since real time status requires host, and ctrl is a member of host.
> Real time status is required for low level commands vs cached status
> since the NAND controller will not do an automatic status read at the
> end of a low level command as it would with a high level command.
>
> Signed-off-by: David Regan <[email protected]>
> Reviewed-by: Florian Fainelli <[email protected]>
Applied to https://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux.git nand/next, thanks.
Miquel