m_can offers the possibility to set an interrupt on reaching a watermark
level in the receive FIFO. This can be used to implement coalescing.
Unfortunately there is no hardware timeout available to trigger an
interrupt if only a few messages were received within a given time. To
solve this I am using a hrtimer to wake up the irq thread after x
microseconds.
The timer is always started if receive coalescing is enabled and new
received frames were available during an interrupt. The timer is stopped
if during a interrupt handling no new data was available.
If the timer is started the new item interrupt is disabled and the
watermark interrupt takes over. If the timer is not started again, the
new item interrupt is enabled again, notifying the handler about every
new item received.
Signed-off-by: Markus Schneider-Pargmann <[email protected]>
---
drivers/net/can/m_can/m_can.c | 77 ++++++++++++++++++++++++++++++++---
drivers/net/can/m_can/m_can.h | 5 +++
2 files changed, 76 insertions(+), 6 deletions(-)
diff --git a/drivers/net/can/m_can/m_can.c b/drivers/net/can/m_can/m_can.c
index a01c9261331d..b76fcf5f3889 100644
--- a/drivers/net/can/m_can/m_can.c
+++ b/drivers/net/can/m_can/m_can.c
@@ -422,6 +422,25 @@ static void m_can_config_endisable(struct m_can_classdev *cdev, bool enable)
}
}
+static void m_can_interrupt_enable(struct m_can_classdev *cdev, u32 interrupts)
+{
+ if (cdev->active_interrupts == interrupts)
+ return;
+ cdev->ops->write_reg(cdev, M_CAN_IE, interrupts);
+ cdev->active_interrupts = interrupts;
+}
+
+static void m_can_coalescing_disable(struct m_can_classdev *cdev)
+{
+ u32 new_interrupts = cdev->active_interrupts | IR_RF0N;
+
+ if (!cdev->net->irq)
+ return;
+
+ hrtimer_cancel(&cdev->hrtimer);
+ m_can_interrupt_enable(cdev, new_interrupts);
+}
+
static inline void m_can_enable_all_interrupts(struct m_can_classdev *cdev)
{
if (!cdev->net->irq) {
@@ -437,7 +456,9 @@ static inline void m_can_enable_all_interrupts(struct m_can_classdev *cdev)
static inline void m_can_disable_all_interrupts(struct m_can_classdev *cdev)
{
+ m_can_coalescing_disable(cdev);
m_can_write(cdev, M_CAN_ILE, 0x0);
+ cdev->active_interrupts = 0x0;
if (!cdev->net->irq) {
dev_dbg(cdev->dev, "Stop hrtimer\n");
@@ -1091,15 +1112,42 @@ static int m_can_echo_tx_event(struct net_device *dev)
return err;
}
+static void m_can_coalescing_update(struct m_can_classdev *cdev, u32 ir)
+{
+ u32 new_interrupts = cdev->active_interrupts;
+ bool enable_timer = false;
+
+ if (!cdev->net->irq)
+ return;
+
+ if (cdev->rx_coalesce_usecs_irq > 0 && (ir & (IR_RF0N | IR_RF0W))) {
+ enable_timer = true;
+ new_interrupts &= ~IR_RF0N;
+ } else if (!hrtimer_active(&cdev->hrtimer)) {
+ new_interrupts |= IR_RF0N;
+ }
+
+ m_can_interrupt_enable(cdev, new_interrupts);
+ if (enable_timer) {
+ hrtimer_start(&cdev->hrtimer,
+ ns_to_ktime(cdev->rx_coalesce_usecs_irq * NSEC_PER_USEC),
+ HRTIMER_MODE_REL);
+ }
+}
+
static irqreturn_t m_can_isr(int irq, void *dev_id)
{
struct net_device *dev = (struct net_device *)dev_id;
struct m_can_classdev *cdev = netdev_priv(dev);
u32 ir;
- if (pm_runtime_suspended(cdev->dev))
+ if (pm_runtime_suspended(cdev->dev)) {
+ m_can_coalescing_disable(cdev);
return IRQ_NONE;
+ }
+
ir = m_can_read(cdev, M_CAN_IR);
+ m_can_coalescing_update(cdev, ir);
if (!ir)
return IRQ_NONE;
@@ -1114,13 +1162,17 @@ static irqreturn_t m_can_isr(int irq, void *dev_id)
* - state change IRQ
* - bus error IRQ and bus error reporting
*/
- if ((ir & IR_RF0N) || (ir & IR_ERR_ALL_30X)) {
+ if (ir & (IR_RF0N | IR_RF0W | IR_ERR_ALL_30X)) {
cdev->irqstatus = ir;
if (!cdev->is_peripheral) {
m_can_disable_all_interrupts(cdev);
napi_schedule(&cdev->napi);
- } else if (m_can_rx_peripheral(dev, ir) < 0) {
- goto out_fail;
+ } else {
+ int pkts;
+
+ pkts = m_can_rx_peripheral(dev, ir);
+ if (pkts < 0)
+ goto out_fail;
}
}
@@ -1156,6 +1208,15 @@ static irqreturn_t m_can_isr(int irq, void *dev_id)
return IRQ_HANDLED;
}
+static enum hrtimer_restart m_can_coalescing_timer(struct hrtimer *timer)
+{
+ struct m_can_classdev *cdev = container_of(timer, struct m_can_classdev, hrtimer);
+
+ irq_wake_thread(cdev->net->irq, cdev->net);
+
+ return HRTIMER_NORESTART;
+}
+
static const struct can_bittiming_const m_can_bittiming_const_30X = {
.name = KBUILD_MODNAME,
.tseg1_min = 2, /* Time segment 1 = prop_seg + phase_seg1 */
@@ -1296,7 +1357,7 @@ static int m_can_chip_config(struct net_device *dev)
/* Disable unused interrupts */
interrupts &= ~(IR_ARA | IR_ELO | IR_DRX | IR_TEFF | IR_TEFW | IR_TFE |
IR_TCF | IR_HPM | IR_RF1F | IR_RF1W | IR_RF1N |
- IR_RF0F | IR_RF0W);
+ IR_RF0F);
m_can_config_endisable(cdev, true);
@@ -1340,6 +1401,7 @@ static int m_can_chip_config(struct net_device *dev)
/* rx fifo configuration, blocking mode, fifo size 1 */
m_can_write(cdev, M_CAN_RXF0C,
+ FIELD_PREP(RXFC_FWM_MASK, cdev->rx_max_coalesced_frames_irq) |
FIELD_PREP(RXFC_FS_MASK, cdev->mcfg[MRAM_RXF0].num) |
cdev->mcfg[MRAM_RXF0].off);
@@ -1398,7 +1460,7 @@ static int m_can_chip_config(struct net_device *dev)
else
interrupts &= ~(IR_ERR_LEC_31X);
}
- m_can_write(cdev, M_CAN_IE, interrupts);
+ m_can_interrupt_enable(cdev, interrupts);
/* route all interrupts to INT0 */
m_can_write(cdev, M_CAN_ILS, ILS_ALL_INT0);
@@ -2082,6 +2144,9 @@ int m_can_class_register(struct m_can_classdev *cdev)
hrtimer_init(&cdev->hrtimer, CLOCK_MONOTONIC,
HRTIMER_MODE_REL_PINNED);
cdev->hrtimer.function = &hrtimer_callback;
+ } else {
+ hrtimer_init(&cdev->hrtimer, CLOCK_MONOTONIC, HRTIMER_MODE_REL);
+ cdev->hrtimer.function = m_can_coalescing_timer;
}
ret = m_can_dev_setup(cdev);
diff --git a/drivers/net/can/m_can/m_can.h b/drivers/net/can/m_can/m_can.h
index 520e14277dff..b916206199f1 100644
--- a/drivers/net/can/m_can/m_can.h
+++ b/drivers/net/can/m_can/m_can.h
@@ -92,6 +92,11 @@ struct m_can_classdev {
int pm_clock_support;
int is_peripheral;
+ // Cached M_CAN_IE register content
+ u32 active_interrupts;
+ u32 rx_max_coalesced_frames_irq;
+ u32 rx_coalesce_usecs_irq;
+
struct mram_cfg mcfg[MRAM_CFG_NUM];
struct hrtimer hrtimer;
--
2.43.0