Am Thu, Feb 15, 2024 at 12:18:41AM +0100 schrieb Javier Carrasco:
> On 14.02.24 09:53, Dimitri Fedrau wrote:
> > Add threshold events support for temperature and relative humidity. To
> > enable them the higher and lower threshold registers must be programmed
> > and the higher threshold must be greater then or equal to the lower
> > threshold. Otherwise the event is disabled. Invalid hysteresis values
> > are ignored by the device. There is no further configuration possible.
> >
> > Tested by setting thresholds/hysteresis and turning the heater on/off.
> > Used iio_event_monitor in tools/iio to catch events while constantly
> > displaying temperature and humidity values.
> >
> > Signed-off-by: Dimitri Fedrau <[email protected]>
> > ---
>
> Hi Dimitri,
>
Hi Javier,
> now that the decimal part is used, the resolution loss is within the
> ranges mentioned in the datasheet.
>
> For the records: the truncated values lead to alerts slightly lower than
> the target alerts. Therefore, measured values below the "comfort zone"
> defined by the user (but close to the low alert) will not trigger
> events. The other way around is "more secure" because the target comfort
> zone is guaranteed:
>
> -------- High val -> event (as expected)
>
> ******** Target High Alert
>
> -------- Meas -> **event** (still in target comfort zone)
>
> ######## Truncated High Alert
>
> ...
>
> ******** Target Low Alert
>
> -------- Meas -> **no event** (out of target comfort zone)
>
> ######## Truncated Low Alert
>
> -------- Meas -> event (as expected)
>
> But as I said, the resolution loss is in the valid range anyway:
>
> Tested-by: Javier Carrasco <[email protected]>
>
> Thank you for adding this feature.
>
thanks for testing.
Best regards,
Dimitri Fedrau