Before commit 07c30ea5861f ("serial: Do not hold the port lock when setting
rx-during-tx GPIO") the SER_RS485_RX_DURING_TX flag was only set if the
rx-during-tx mode was not controlled by a GPIO. Now the flag is set
unconditionally when RS485 is enabled. This results in an incorrect setting
if the rx-during-tx GPIO is not asserted.
Fix this by setting the flag only if the rx-during-tx mode is not
controlled by a GPIO and thus restore the correct behaviour.
Cc: <[email protected]> # 6.6+
Fixes: 07c30ea5861f ("serial: Do not hold the port lock when setting rx-during-tx GPIO")
Signed-off-by: Lino Sanfilippo <[email protected]>
---
drivers/tty/serial/stm32-usart.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 794b77512740..693e932d6feb 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -251,7 +251,9 @@ static int stm32_usart_config_rs485(struct uart_port *port, struct ktermios *ter
writel_relaxed(cr3, port->membase + ofs->cr3);
writel_relaxed(cr1, port->membase + ofs->cr1);
- rs485conf->flags |= SER_RS485_RX_DURING_TX;
+ if (!port->rs485_rx_during_tx_gpio)
+ rs485conf->flags |= SER_RS485_RX_DURING_TX;
+
} else {
stm32_usart_clr_bits(port, ofs->cr3,
USART_CR3_DEM | USART_CR3_DEP);
base-commit: 841c35169323cd833294798e58b9bf63fa4fa1de
--
2.43.0