Qualcomm ROME controllers can be registered from the Bluetooth line
discipline and in this case the HCI UART serdev pointer is NULL.
Add the missing sanity check to prevent a NULL-pointer dereference when
setup() is called for a non-serdev controller.
Fixes: e9b3e5b8c657 ("Bluetooth: hci_qca: only assign wakeup with serial port support")
Cc: [email protected] # 6.2
Cc: Zhengping Jiang <[email protected]>
Signed-off-by: Johan Hovold <[email protected]>
---
drivers/bluetooth/hci_qca.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 84f728943962..6a69a7f9ef64 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1960,8 +1960,10 @@ static int qca_setup(struct hci_uart *hu)
qca_debugfs_init(hdev);
hu->hdev->hw_error = qca_hw_error;
hu->hdev->cmd_timeout = qca_cmd_timeout;
- if (device_can_wakeup(hu->serdev->ctrl->dev.parent))
- hu->hdev->wakeup = qca_wakeup;
+ if (hu->serdev) {
+ if (device_can_wakeup(hu->serdev->ctrl->dev.parent))
+ hu->hdev->wakeup = qca_wakeup;
+ }
} else if (ret == -ENOENT) {
/* No patch/nvm-config found, run with original fw/config */
set_bit(QCA_ROM_FW, &qca->flags);
--
2.43.2