On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge
for each controller instance. Hence, add a node to represent the bridge.
Signed-off-by: Manivannan Sadhasivam <[email protected]>
---
arch/arm/boot/dts/qcom/qcom-apq8064.dtsi | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/arch/arm/boot/dts/qcom/qcom-apq8064.dtsi b/arch/arm/boot/dts/qcom/qcom-apq8064.dtsi
index 9a5ba978775a..dbe0ae2c8770 100644
--- a/arch/arm/boot/dts/qcom/qcom-apq8064.dtsi
+++ b/arch/arm/boot/dts/qcom/qcom-apq8064.dtsi
@@ -1334,6 +1334,16 @@ pcie: pcie@1b500000 {
<&gcc PCIE_PHY_RESET>;
reset-names = "axi", "ahb", "por", "pci", "phy";
status = "disabled";
+
+ pcie@0 {
+ device_type = "pci";
+ reg = <0x0 0x0 0x0 0x0 0x0>;
+ bus-range = <0x01 0xff>;
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+ };
};
hdmi: hdmi-tx@4a00000 {
--
2.25.1