From: Konstantin Pugin <[email protected]>
When specifying flag SER_RS485_RTS_ON_SEND in RS485 configuration,
we get the following warning after commit 4afeced55baa ("serial: core:
fix sanitizing check for RTS settings"):
invalid RTS setting, using RTS_AFTER_SEND instead
This results in SER_RS485_RTS_AFTER_SEND being set and the
driver always write to the register field SC16IS7XX_EFCR_RTS_INVERT_BIT,
which breaks some hardware using these chips.
The hardware supports both RTS_ON_SEND and RTS_AFTER_SEND modes, so fix
this by announcing support for RTS_ON_SEND.
Fixes: 267913ecf737 ("serial: sc16is7xx: Fill in rs485_supported")
Tested-by: Hugo Villeneuve <[email protected]>
Reviewed-by: Andy Shevchenko <[email protected]>
Signed-off-by: Konstantin Pugin <[email protected]>
---
drivers/tty/serial/sc16is7xx.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c
index 03cf30e20b75..dfcc804f558f 100644
--- a/drivers/tty/serial/sc16is7xx.c
+++ b/drivers/tty/serial/sc16is7xx.c
@@ -1449,7 +1449,7 @@ static int sc16is7xx_setup_mctrl_ports(struct sc16is7xx_port *s,
}
static const struct serial_rs485 sc16is7xx_rs485_supported = {
- .flags = SER_RS485_ENABLED | SER_RS485_RTS_AFTER_SEND,
+ .flags = SER_RS485_ENABLED | SER_RS485_RTS_ON_SEND | SER_RS485_RTS_AFTER_SEND,
.delay_rts_before_send = 1,
.delay_rts_after_send = 1, /* Not supported but keep returning -EINVAL */
};
--
2.44.0