Add multicast filtering support for ICSSG Driver.
Signed-off-by: MD Danish Anwar <[email protected]>
---
drivers/net/ethernet/ti/icssg/icssg_config.c | 16 +++++--
drivers/net/ethernet/ti/icssg/icssg_prueth.c | 50 ++++++++++++++++++--
drivers/net/ethernet/ti/icssg/icssg_prueth.h | 3 ++
3 files changed, 62 insertions(+), 7 deletions(-)
diff --git a/drivers/net/ethernet/ti/icssg/icssg_config.c b/drivers/net/ethernet/ti/icssg/icssg_config.c
index 2213374d4d45..4e30bb995078 100644
--- a/drivers/net/ethernet/ti/icssg/icssg_config.c
+++ b/drivers/net/ethernet/ti/icssg/icssg_config.c
@@ -318,17 +318,27 @@ static int prueth_emac_buffer_setup(struct prueth_emac *emac)
static void icssg_init_emac_mode(struct prueth *prueth)
{
+ u32 addr = prueth->shram.pa + VLAN_STATIC_REG_TABLE_OFFSET;
/* When the device is configured as a bridge and it is being brought
* back to the emac mode, the host mac address has to be set as 0.
*/
u8 mac[ETH_ALEN] = { 0 };
+ int i;
if (prueth->emacs_initialized)
return;
- regmap_update_bits(prueth->miig_rt, FDB_GEN_CFG1,
- SMEM_VLAN_OFFSET_MASK, 0);
- regmap_write(prueth->miig_rt, FDB_GEN_CFG2, 0);
+ /* Set VLAN TABLE address base */
+ regmap_update_bits(prueth->miig_rt, FDB_GEN_CFG1, SMEM_VLAN_OFFSET_MASK,
+ addr << SMEM_VLAN_OFFSET);
+ /* Configure CFG2 register */
+ regmap_write(prueth->miig_rt, FDB_GEN_CFG2, (FDB_PRU0_EN | FDB_PRU1_EN | FDB_HOST_EN));
+
+ prueth->vlan_tbl = prueth->shram.va + VLAN_STATIC_REG_TABLE_OFFSET;
+ for (i = 0; i < SZ_4K - 1; i++) {
+ prueth->vlan_tbl[i].fid = i;
+ prueth->vlan_tbl[i].fid_c1 = 0;
+ }
/* Clear host MAC address */
icssg_class_set_host_mac_addr(prueth->miig_rt, mac);
}
diff --git a/drivers/net/ethernet/ti/icssg/icssg_prueth.c b/drivers/net/ethernet/ti/icssg/icssg_prueth.c
index 7c9e9518f555..bd343c4b6b57 100644
--- a/drivers/net/ethernet/ti/icssg/icssg_prueth.c
+++ b/drivers/net/ethernet/ti/icssg/icssg_prueth.c
@@ -417,6 +417,37 @@ const struct icss_iep_clockops prueth_iep_clockops = {
.perout_enable = prueth_perout_enable,
};
+static int icssg_prueth_mac_add_mcast(struct net_device *ndev, const u8 *addr)
+{
+ struct prueth_emac *emac = netdev_priv(ndev);
+ int port_mask = BIT(emac->port_id);
+
+ port_mask |= icssg_fdb_lookup(emac, addr, 0);
+ icssg_fdb_add_del(emac, addr, 0, port_mask, true);
+ icssg_vtbl_modify(emac, 0, port_mask, port_mask, true);
+
+ return 0;
+}
+
+static int icssg_prueth_mac_del_mcast(struct net_device *ndev, const u8 *addr)
+{
+ struct prueth_emac *emac = netdev_priv(ndev);
+ int port_mask = BIT(emac->port_id);
+ int other_port_mask;
+
+ other_port_mask = port_mask ^ icssg_fdb_lookup(emac, addr, 0);
+
+ icssg_fdb_add_del(emac, addr, 0, port_mask, false);
+ icssg_vtbl_modify(emac, 0, port_mask, port_mask, false);
+
+ if (other_port_mask) {
+ icssg_fdb_add_del(emac, addr, 0, other_port_mask, true);
+ icssg_vtbl_modify(emac, 0, other_port_mask, other_port_mask, true);
+ }
+
+ return 0;
+}
+
/**
* emac_ndo_open - EMAC device open
* @ndev: network adapter device
@@ -526,6 +557,8 @@ static int emac_ndo_open(struct net_device *ndev)
prueth->emacs_initialized++;
+ __hw_addr_init(&emac->mcast_list);
+
queue_work(system_long_wq, &emac->stats_work.work);
return 0;
@@ -578,6 +611,9 @@ static int emac_ndo_stop(struct net_device *ndev)
icssg_class_disable(prueth->miig_rt, prueth_emac_slice(emac));
+ __dev_mc_unsync(ndev, icssg_prueth_mac_del_mcast);
+ __hw_addr_init(&emac->mcast_list);
+
atomic_set(&emac->tdown_cnt, emac->tx_ch_num);
/* ensure new tdown_cnt value is visible */
smp_mb__after_atomic();
@@ -654,10 +690,15 @@ static void emac_ndo_set_rx_mode_work(struct work_struct *work)
return;
}
- if (!netdev_mc_empty(ndev)) {
- emac_set_port_state(emac, ICSSG_EMAC_PORT_MC_FLOODING_ENABLE);
- return;
- }
+ /* make a mc list copy */
+
+ netif_addr_lock_bh(ndev);
+ __hw_addr_sync(&emac->mcast_list, &ndev->mc, ndev->addr_len);
+ netif_addr_unlock_bh(ndev);
+
+ __hw_addr_sync_dev(&emac->mcast_list, ndev,
+ icssg_prueth_mac_add_mcast,
+ icssg_prueth_mac_del_mcast);
}
/**
@@ -746,6 +787,7 @@ static int prueth_netdev_init(struct prueth *prueth,
SET_NETDEV_DEV(ndev, prueth->dev);
spin_lock_init(&emac->lock);
mutex_init(&emac->cmd_lock);
+ __hw_addr_init(&emac->mcast_list);
emac->phy_node = of_parse_phandle(eth_node, "phy-handle", 0);
if (!emac->phy_node && !of_phy_is_fixed_link(eth_node)) {
diff --git a/drivers/net/ethernet/ti/icssg/icssg_prueth.h b/drivers/net/ethernet/ti/icssg/icssg_prueth.h
index 82bdad9702c3..0cad80a437e8 100644
--- a/drivers/net/ethernet/ti/icssg/icssg_prueth.h
+++ b/drivers/net/ethernet/ti/icssg/icssg_prueth.h
@@ -155,6 +155,9 @@ struct prueth_emac {
unsigned int tx_ts_enabled : 1;
unsigned int half_duplex : 1;
+ /* List for storing mutlicast addresses */
+ struct netdev_hw_addr_list mcast_list;
+
/* DMA related */
struct prueth_tx_chn tx_chns[PRUETH_MAX_TX_QUEUES];
struct completion tdown_complete;
--
2.34.1
On Thu, May 16, 2024 at 02:47:52PM +0530, MD Danish Anwar wrote:
> Add multicast filtering support for ICSSG Driver.
>
> Signed-off-by: MD Danish Anwar <[email protected]>
> ---
> drivers/net/ethernet/ti/icssg/icssg_config.c | 16 +++++--
> drivers/net/ethernet/ti/icssg/icssg_prueth.c | 50 ++++++++++++++++++--
> drivers/net/ethernet/ti/icssg/icssg_prueth.h | 3 ++
> 3 files changed, 62 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/net/ethernet/ti/icssg/icssg_config.c b/drivers/net/ethernet/ti/icssg/icssg_config.c
> index 2213374d4d45..4e30bb995078 100644
> --- a/drivers/net/ethernet/ti/icssg/icssg_config.c
> +++ b/drivers/net/ethernet/ti/icssg/icssg_config.c
> @@ -318,17 +318,27 @@ static int prueth_emac_buffer_setup(struct prueth_emac *emac)
>
> static void icssg_init_emac_mode(struct prueth *prueth)
> {
> + u32 addr = prueth->shram.pa + VLAN_STATIC_REG_TABLE_OFFSET;
> /* When the device is configured as a bridge and it is being brought
> * back to the emac mode, the host mac address has to be set as 0.
> */
> u8 mac[ETH_ALEN] = { 0 };
> + int i;
>
> if (prueth->emacs_initialized)
> return;
>
> - regmap_update_bits(prueth->miig_rt, FDB_GEN_CFG1,
> - SMEM_VLAN_OFFSET_MASK, 0);
> - regmap_write(prueth->miig_rt, FDB_GEN_CFG2, 0);
> + /* Set VLAN TABLE address base */
> + regmap_update_bits(prueth->miig_rt, FDB_GEN_CFG1, SMEM_VLAN_OFFSET_MASK,
> + addr << SMEM_VLAN_OFFSET);
> + /* Configure CFG2 register */
> + regmap_write(prueth->miig_rt, FDB_GEN_CFG2, (FDB_PRU0_EN | FDB_PRU1_EN | FDB_HOST_EN));
> +
> + prueth->vlan_tbl = prueth->shram.va + VLAN_STATIC_REG_TABLE_OFFSET;
> + for (i = 0; i < SZ_4K - 1; i++) {
> + prueth->vlan_tbl[i].fid = i;
> + prueth->vlan_tbl[i].fid_c1 = 0;
> + }
Hi MD,
This isnot a full review, but I did notice one thing.
According to Sparse, prueth->shram.va is __iomem.
I don't think it is portable to directly access __iomem like this.
Rather, I suspect that either ioremap(), or writel() or similar should be used.
> /* Clear host MAC address */
> icssg_class_set_host_mac_addr(prueth->miig_rt, mac);
> }
..