Currently, when an adapter defines a max_write_len quirk,
the data will be chunked into data sizes equal to the
max_write_len quirk value. But the payload will be increased by
the size of the register address before transmission. The
resulting value always ends up larger than the limit set
by the quirk.
Avoid this error by setting regmap's max_write to the quirk's
max_write_len minus the number of bytes for the register. This
allows the chunking to work correctly for this limited case
without impacting other use-cases.
Signed-off-by: Jim Wylder <[email protected]>
---
drivers/base/regmap/regmap-i2c.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/base/regmap/regmap-i2c.c b/drivers/base/regmap/regmap-i2c.c
index 3ec611dc0c09..3b1e78e845bf 100644
--- a/drivers/base/regmap/regmap-i2c.c
+++ b/drivers/base/regmap/regmap-i2c.c
@@ -350,7 +350,7 @@ static const struct regmap_bus *regmap_get_i2c_bus(struct i2c_client *i2c,
if (quirks->max_write_len &&
(bus->max_raw_write == 0 || bus->max_raw_write > quirks->max_write_len))
- max_write = quirks->max_write_len;
+ max_write = quirks->max_write_len - config->reg_bits / BITS_PER_BYTE;
if (max_read || max_write) {
ret_bus = kmemdup(bus, sizeof(*bus), GFP_KERNEL);
--
2.45.0.rc1.225.g2a3ae87e7f-goog