This patchset adds the new PWR regulators compatible for STM32MP13:
"st,stm32mp13-pwr-reg".
As this node is just introduced by [1] and it is is not used by any
board in Linux, it is the good time to introduced this compatible
and update the STM32MP13 SoC dtsi without ABI break.
A new compatible is needed as the content of the PWR_CR3 register,
used by this driver change with new bits on STM32MP13 for SD IO domain:
- bit 23: VDDSD2VALID
- bit 22: VDDSD1VALID
- bit 16: VDDSD2RDY
- bit 15: VDDSD2EN
- bit 14: VDDSD1RDY
- bit 13: VDDSD1EN
I will push a update on STM32MP13 SoC dtsi if this new compatible
is accepted to preserve the bisectability.
[1] commit f798f7079233 ("ARM: dts: stm32: add PWR regulators support on stm32mp131")
https://lore.kernel.org/linux-arm-kernel/[email protected]/
Changes in v4:
- use fallback as proposed by Marek on V3 for STM32MP13:
compatible = "st,stm32mp13-pwr-reg", "st,stm32mp1,pwr-reg"
Changes in v3:
- Replace oneOf/const by enum; solve the V2 issues for dt_binding_check
Changes in v2:
- Add new compatible for STM32MP13 and change title after Rob remarks
V1: "ARM: st: use a correct pwr compatible for stm32mp15"
Patrick Delaunay (2):
dt-bindings: regulator: st,stm32mp1-pwr-reg: add compatible for
STM32MP13
regulator: stm32-pwr: add support of STM32MP13
.../devicetree/bindings/regulator/st,stm32mp1-pwr-reg.yaml | 7 ++++++-
drivers/regulator/stm32-pwr.c | 1 +
2 files changed, 7 insertions(+), 1 deletion(-)
--
2.25.1