EDID cannot be read on RK3328 until after read_hpd has been called and
correct io voltage has been configured based on connection status.
When a forced mode is used, e.g. video=1920x1080@60e, the connector
detect ops, that in turn normally calls the read_hpd, never gets called.
This result in reading EDID to fail in connector get_modes ops.
Call dw_hdmi_rk3328_read_hpd at end of dw_hdmi_rk3328_setup_hpd to
correct io voltage and allow reading EDID after setup_hpd.
Fixes: 1c53ba8f22a1 ("drm/rockchip: dw_hdmi: add dw-hdmi support for the rk3328")
Signed-off-by: Jonas Karlman <[email protected]>
---
drivers/gpu/drm/rockchip/dw_hdmi-rockchip.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/gpu/drm/rockchip/dw_hdmi-rockchip.c b/drivers/gpu/drm/rockchip/dw_hdmi-rockchip.c
index fe33092abbe7..aae48e906af1 100644
--- a/drivers/gpu/drm/rockchip/dw_hdmi-rockchip.c
+++ b/drivers/gpu/drm/rockchip/dw_hdmi-rockchip.c
@@ -434,6 +434,8 @@ static void dw_hdmi_rk3328_setup_hpd(struct dw_hdmi *dw_hdmi, void *data)
HIWORD_UPDATE(RK3328_HDMI_SDAIN_MSK | RK3328_HDMI_SCLIN_MSK,
RK3328_HDMI_SDAIN_MSK | RK3328_HDMI_SCLIN_MSK |
RK3328_HDMI_HPD_IOE));
+
+ dw_hdmi_rk3328_read_hpd(dw_hdmi, data);
}
static const struct dw_hdmi_phy_ops rk3228_hdmi_phy_ops = {
--
2.45.2