The attached p21 patch doesn't change anything.
But another one from the mail-text is good
void phylink_disconnect_phy(struct phylink *pl)
+ pl->phy_state.link = false;
There still (not for my MRVL-PP2) problem:
It is expected that on ifconfig-down the callback
pl->ops->mac_link_down(ndev, pl->link_an_mode);
would be called, but it isn't
-----Original Message-----
From: Russell King - ARM Linux [mailto:[email protected]]
Sent: Wednesday, November 29, 2017 9:59 PM
To: Yan Markman <[email protected]>
Cc: Antoine Tenart <[email protected]>; [email protected]; [email protected]; [email protected]; [email protected]; [email protected]; [email protected]; Nadav Haklai <[email protected]>; [email protected]; Stefan Chulski <[email protected]>; [email protected]; [email protected]
Subject: [EXT] Re: [PATCH net] net: phylink: fix link state on phy-connect
External Email
----------------------------------------------------------------------
On Wed, Nov 29, 2017 at 07:33:44PM +0000, Yan Markman wrote:
> Hi Russel
>
> On my board I have [Marvell 88E1510] phy working with STATUS-POLLING I
> see some inconsistencies -- first ifconfig-up is different from furthers, no "link is down" reports.
> Please refer the behavior example below.
> My patch is a "simple solution" -- always reset/clear Link-state-parameters before going UP.
> Possibly, more correct (but much more complicated) solution would be in the phy state machine and phylink resolve modification.
> I just found that
> On ifconfig-down, the phy-state-machine and phylink-resolve
> are stopped before executing before passing over full graceful down/reset state.
> The further ifconfig-up starts with old state parameters.
> Special cases not-tested but logic 2 test-cases are:
> remote side changes speed whilst link is Down or Disconnected. But local ifconfig-up starts with old speed.
Hi,
I think this is covered in my "phy" branch - but could probably do with further testing, specifically this patch (which I've attached):
"phylink: ensure we take the link down when phylink_stop() is called"
This takes the link down on the MAC side synchronously when phylink_stop() is called. However, I think your case might also benefit from this patch - please test the patch referred to without this change, and let me know if you need this change to solve your problem:
diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c index 8f43f8779317..c90ad50204b0 100644
--- a/drivers/net/phy/phylink.c
+++ b/drivers/net/phy/phylink.c
@@ -798,6 +798,7 @@ void phylink_disconnect_phy(struct phylink *pl)
mutex_lock(&pl->state_mutex);
pl->netdev->phydev = NULL;
pl->phydev = NULL;
+ pl->phy_state.link = false;
mutex_unlock(&pl->state_mutex);
mutex_unlock(&phy->lock);
flush_work(&pl->resolve);
Thanks.
--
RMK's Patch system: http://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 8.8Mbps down 630kbps up According to speedtest.net: 8.21Mbps down 510kbps up
From 1585431859376545053@xxx Wed Nov 29 20:00:44 +0000 2017
X-GM-THRID: 1585316788419333533
X-Gmail-Labels: Inbox,Category Forums,HistoricalUnread