On 08.01.2021 16:45, Claudiu Beznea wrote:
> KSZ9131 is used in setups with SAMA7G5. SAMA7G5 supports a special
> power saving mode (backup mode) that cuts the power for almost all
> parts of the SoC. The rail powering the ethernet PHY is also cut off.
> When resuming, in case the PHY has been configured on probe with
> slew rate or DLL settings these needs to be restored thus call
> driver's config_init() on resume.
>
When would the SoC enter this backup mode? And would it suspend the
MDIO bus before cutting power to the PHY?
I'm asking because in mdio_bus_phy_restore() we call phy_init_hw()
already (that calls the driver's config_init).
> Signed-off-by: Claudiu Beznea <[email protected]>
> ---
> drivers/net/phy/micrel.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
> index 3fe552675dd2..52d3a0480158 100644
> --- a/drivers/net/phy/micrel.c
> +++ b/drivers/net/phy/micrel.c
> @@ -1077,7 +1077,7 @@ static int kszphy_resume(struct phy_device *phydev)
> */
> usleep_range(1000, 2000);
>
> - ret = kszphy_config_reset(phydev);
> + ret = phydev->drv->config_init(phydev);
> if (ret)
> return ret;
>
>