Nuno Alexandre wrote:
>On Tue, 30 Dec 2003 11:44:01 +0100
>Mr(s): Nicklas Bondesson wrote:
>
>
>
>>Hi!
>>
>>I think i'm getting really bad values from my disks. It's two Western
>>Digital WD800JB-00DUA3 (Special Edition 8 MB cache) disks connected to a
>>Promise TX2000 (PDC20271) card (RAID1 using ataraid under Linux 2.4.23).
>>
>>The disks are setup with hdparm at boot time:
>>
>>/sbin/hdparm -X69 -d1 -u1 -m16 -c3 /dev/hda
>>/sbin/hdparm -X69 -d1 -u1 -m16 -c3 /dev/hdc
>>
>>When running hdparm -tT I get the following:
>>
>>/dev/hda:
>> Timing buffer-cache reads: 128 MB in 1.13 seconds =113.27 MB/sec
>> Timing buffered disk reads: 64 MB in 2.46 seconds = 26.02 MB/sec
>>
>>/dev/hdc:
>> Timing buffer-cache reads: 128 MB in 1.13 seconds =113.27 MB/sec
>> Timing buffered disk reads: 64 MB in 2.47 seconds = 25.91 MB/sec
>>
>>Are these normal values? I don't think so. Please advise.
>>
>>/Nicke
>>
>>
>
>Hi.
>This is what i get with a Maxtor 6Y120L0 (2MB cache):
>
>/dev/hda:
> Timing buffer-cache reads: 1320 MB in 2.00 seconds = 659.44 MB/sec
> Timing buffered disk reads: 140 MB in 3.02 seconds = 46.40 MB/sec
>
>Using:
>-d1 -u1 -m16 -c3 -W1 -A1 -k1 -X70 -a 8192
>
>I'm not using raid, its a single disk connected to IDE1 on the motherboard.
>
>Maybe you can try those parameters and see if it helps :)
>
>
I have two promise cards and four Maxtor
DiamondMax Plus9 60G with 8MB cache each
hdparm -d1 -u1 -m16 -c1 -W1 -A1 -k1 -X70 -a 8192
and my raid0 is software, linux, not the promise chip's raid
on each drive I see 900 MB/s 47.2 MB/s
and on /dev/md/2 /tmp with four drives
four partitions I see 900 MB/s 94 MB/s
that's with 64k raid chunk, reiser 4096b blocks
Linux says 2048k raid chunk would minimize
seek time for better real world performance. It
doesn't work better with hdparm -tT but that's not
realworld. My version of reiserfs doesn't allow
changing the block size.
-Bob D