I recently was given a surecom 10/100 ethernet card and found that i
could not change Mac address for it as other driver/devices allow.
I tried to implement the missing feature and noticed that the device is
quite peculiar (or either my system is broken), when trying to fill mac
address registers (no matter whether io_ops is set):
- If I write a byte (writeb) to an even i/o address it seems like
actually a word was written (the next byte is set to 0).
- If I write a byte to an odd i/o address my pc gets bad freezed.
That made think of writing 16bit words (writew) for the memory address,
as opposed to what most driver examples do. It works for me (I hope i
set the lines at the right place in device_open function after the
device is reset). I hope the code is clean enough and does not mess with
byte ordering. This is the patch (this time against 2.6.5):
--- linux-2.6.5.orig/drivers/net/fealnx.c 2004-04-09
05:04:20.000000000 +0200
+++ linux/drivers/net/fealnx.c 2004-04-23 01:47:38.000000000 +0200
@@ -882,12 +882,17 @@
{
struct netdev_private *np = dev->priv;
long ioaddr = dev->base_addr;
-
+ int i;
+
writel(0x00000001, ioaddr + BCR); /* Reset */
if (request_irq(dev->irq, &intr_handler, SA_SHIRQ, dev->name, dev))
return -EAGAIN;
+ for (i = 0; i < 3; i++) {
+ writew(((unsigned short*)dev->dev_addr)[i], ioaddr +
PAR0 + i*2);
+ }
+
init_ring(dev);
writel(np->rx_ring_dma, ioaddr + RXLBA);
----
By the way, i get some Watchdog Timeouts while transmitting every 10
minutes or so (also with 2.4 and original drivers).
This is what i get:
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status 00000000, resetting...
Rx ring cf674000: 80000000 80000000 80000000 80000000 80000000
80000000 80000000 80000000 80000000 80000000 80000000 80000000
Tx ring cf675000: 80000000 80000000 80000000 80000000 80000000 0000
I have also recently experienced problems with my cablemodem Motorola
SB5100e. It has registered this mac address:
D4:62:00:02:44:1F
which does not exist but is a mixture of my surecom card (fealnx)
00:02:44:1F:5F:59 and the network gateway 00:05:00:E2:D4:62.
I am not sure who's fault this is (i would not trust my cablemodem much
anyway).
Thank you for reading.
On Friday 23 April 2004 03:05, SuD (Alex) wrote:
>...
> By the way, i get some Watchdog Timeouts while transmitting every 10
> minutes or so (also with 2.4 and original drivers).
> This is what i get:
> NETDEV WATCHDOG: eth0: transmit timed out
> eth0: Transmit timed out, status 00000000, resetting...
> Rx ring cf674000: 80000000 80000000 80000000 80000000 80000000
> 80000000 80000000 80000000 80000000 80000000 80000000 80000000
> Tx ring cf675000: 80000000 80000000 80000000 80000000 80000000 0000
Hi Alex,
We were working on this recently.
Jeff Garzik just applied patches (to 2.6) which may fix timeout problem.
> I have also recently experienced problems with my cablemodem Motorola
> SB5100e. It has registered this mac address:
> D4:62:00:02:44:1F
> which does not exist but is a mixture of my surecom card (fealnx)
> 00:02:44:1F:5F:59 and the network gateway 00:05:00:E2:D4:62.
> I am not sure who's fault this is (i would not trust my cablemodem much
> anyway).
Unfortunately, I do not have this hardware, but hope to
get it back from a friend soon. Will try to reproduce.
If I don't email you in a week, feel free to remind me.
--
vda