From: Henrik Kretzschmar <[email protected]>
Remove the changelog from the scsi ips driver, since there is and up-to-date
version of that changelog under Documentation/scsi/Changelog.ips.
I added a comment to mention that there is a changelog and where it exists.
Signed-off-by: Henrik Kretzschmar <[email protected]>
---
--- linux-2.6.18-rc4/drivers/scsi/ips.c 2006-08-11 10:09:20.000000000 +0200
+++ linux/drivers/scsi/ips.c 2006-08-20 21:39:21.000000000 +0200
@@ -51,96 +51,7 @@
/* */
/*****************************************************************************/
-/*****************************************************************************/
-/* Change Log */
-/* */
-/* 0.99.02 - Breakup commands that are bigger than 8 * the stripe size */
-/* 0.99.03 - Make interrupt routine handle all completed request on the */
-/* adapter not just the first one */
-/* - Make sure passthru commands get woken up if we run out of */
-/* SCBs */
-/* - Send all of the commands on the queue at once rather than */
-/* one at a time since the card will support it. */
-/* 0.99.04 - Fix race condition in the passthru mechanism -- this required */
-/* the interface to the utilities to change */
-/* - Fix error recovery code */
-/* 0.99.05 - Fix an oops when we get certain passthru commands */
-/* 1.00.00 - Initial Public Release */
-/* Functionally equivalent to 0.99.05 */
-/* 3.60.00 - Bump max commands to 128 for use with firmware 3.60 */
-/* - Change version to 3.60 to coincide with release numbering. */
-/* 3.60.01 - Remove bogus error check in passthru routine */
-/* 3.60.02 - Make DCDB direction based on lookup table */
-/* - Only allow one DCDB command to a SCSI ID at a time */
-/* 4.00.00 - Add support for ServeRAID 4 */
-/* 4.00.01 - Add support for First Failure Data Capture */
-/* 4.00.02 - Fix problem with PT DCDB with no buffer */
-/* 4.00.03 - Add alternative passthru interface */
-/* - Add ability to flash BIOS */
-/* 4.00.04 - Rename structures/constants to be prefixed with IPS_ */
-/* 4.00.05 - Remove wish_block from init routine */
-/* - Use linux/spinlock.h instead of asm/spinlock.h for kernels */
-/* 2.3.18 and later */
-/* - Sync with other changes from the 2.3 kernels */
-/* 4.00.06 - Fix timeout with initial FFDC command */
-/* 4.00.06a - Port to 2.4 (trivial) -- Christoph Hellwig <[email protected]> */
-/* 4.10.00 - Add support for ServeRAID 4M/4L */
-/* 4.10.13 - Fix for dynamic unload and proc file system */
-/* 4.20.03 - Rename version to coincide with new release schedules */
-/* Performance fixes */
-/* Fix truncation of /proc files with cat */
-/* Merge in changes through kernel 2.4.0test1ac21 */
-/* 4.20.13 - Fix some failure cases / reset code */
-/* - Hook into the reboot_notifier to flush the controller cache */
-/* 4.50.01 - Fix problem when there is a hole in logical drive numbering */
-/* 4.70.09 - Use a Common ( Large Buffer ) for Flashing from the JCRM CD */
-/* - Add IPSSEND Flash Support */
-/* - Set Sense Data for Unknown SCSI Command */
-/* - Use Slot Number from NVRAM Page 5 */
-/* - Restore caller's DCDB Structure */
-/* 4.70.12 - Corrective actions for bad controller ( during initialization )*/
-/* 4.70.13 - Don't Send CDB's if we already know the device is not present */
-/* - Don't release HA Lock in ips_next() until SC taken off queue */
-/* - Unregister SCSI device in ips_release() */
-/* 4.70.15 - Fix Breakup for very large ( non-SG ) requests in ips_done() */
-/* 4.71.00 - Change all memory allocations to not use GFP_DMA flag */
-/* Code Clean-Up for 2.4.x kernel */
-/* 4.72.00 - Allow for a Scatter-Gather Element to exceed MAX_XFER Size */
-/* 4.72.01 - I/O Mapped Memory release ( so "insmod ips" does not Fail ) */
-/* - Don't Issue Internal FFDC Command if there are Active Commands */
-/* - Close Window for getting too many IOCTL's active */
-/* 4.80.00 - Make ia64 Safe */
-/* 4.80.04 - Eliminate calls to strtok() if 2.4.x or greater */
-/* - Adjustments to Device Queue Depth */
-/* 4.80.14 - Take all semaphores off stack */
-/* - Clean Up New_IOCTL path */
-/* 4.80.20 - Set max_sectors in Scsi_Host structure ( if >= 2.4.7 kernel ) */
-/* - 5 second delay needed after resetting an i960 adapter */
-/* 4.80.26 - Clean up potential code problems ( Arjan's recommendations ) */
-/* 4.90.01 - Version Matching for FirmWare, BIOS, and Driver */
-/* 4.90.05 - Use New PCI Architecture to facilitate Hot Plug Development */
-/* 4.90.08 - Increase Delays in Flashing ( Trombone Only - 4H ) */
-/* 4.90.08 - Data Corruption if First Scatter Gather Element is > 64K */
-/* 4.90.11 - Don't actually RESET unless it's physically required */
-/* - Remove unused compile options */
-/* 5.00.01 - Sarasota ( 5i ) adapters must always be scanned first */
-/* - Get rid on IOCTL_NEW_COMMAND code */
-/* - Add Extended DCDB Commands for Tape Support in 5I */
-/* 5.10.12 - use pci_dma interfaces, update for 2.5 kernel changes */
-/* 5.10.15 - remove unused code (sem, macros, etc.) */
-/* 5.30.00 - use __devexit_p() */
-/* 6.00.00 - Add 6x Adapters and Battery Flash */
-/* 6.10.00 - Remove 1G Addressing Limitations */
-/* 6.11.xx - Get VersionInfo buffer off the stack ! DDTS 60401 */
-/* 6.11.xx - Make Logical Drive Info structure safe for DMA DDTS 60639 */
-/* 7.10.18 - Add highmem_io flag in SCSI Templete for 2.4 kernels */
-/* - Fix path/name for scsi_hosts.h include for 2.6 kernels */
-/* - Fix sort order of 7k */
-/* - Remove 3 unused "inline" functions */
-/* 7.12.xx - Use STATIC functions whereever possible */
-/* - Clean up deprecated MODULE_PARM calls */
-/* 7.12.05 - Remove Version Matching per IBM request */
-/*****************************************************************************/
+/* ChangeLog is available under Documentation/scsi/Changelog.ips */
/*
* Conditional Compilation directives for this driver: