Hi !
I'm trying to use a dongle for ndiswrapper, but it fails because a
problem of usb. Note that the problem appear when ndiswrapper is fully
uninstalled (and others packages as ndiswrapper-utils, with modprobe -r,
etc...).
So ; when I get on the first time the dongle, a lsusb give :
Bus 001 Device 002: ID 0457:0163 Silicon Integrated Systems Corps.
Bus 001 Device 001: ID 0000:0000
But, a few seconds later, the dongle is not recognize with sometimes an
error -71.
Then, lsusb forget the driver and get :
Bus 001 Device 001: ID 0000:0000
How can I configure the kernel to have the good configuration ? I tried
different ways, but it fails.
I already reinstalled the bios.
See at below for the result of these commands (when I try the dongle) :
"lspci -v |grep HCI"
"cat /var/log/messages" (the end)
"dmesg |grep usb"
Thanks for help,
Thibaud.
NB1 : thanks to Alex Davis and Oliver Neukum for advices and
recommendations about check if the problem was from ndiswrapper or not.
I hope there is not a special list for kernel USB ; if yes : apologizes,
I couldn't find it.
NB2 : I'm not sure if this message is too long or not. I included the
mention "End of the message" at last.
---------------
My hardware :
Computer : dell pentium mmx 233 mst
ram : 128 Mo
dongle : thomson WLG-1500A - chipset Sis163u
Kernel 2.6.19
Ubuntu Edgy
"lspci -v |grep HCI" :
00:01.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev
01) (prog-if 00 [UHCI])
-------------
"cat /var/log/messages"
Feb 11 21:41:08 localhost kernel: [ 6049.104000] usb 1-1: new full speed
USB device using uhci_hcd and address 2
Feb 11 21:41:08 localhost kernel: [ 6049.252000] usb 1-1: configuration
#1 chosen from 1 choice
Feb 11 21:41:12 localhost kernel: [ 6053.592000] usb 1-1: USB
disconnect, address 2
Feb 11 21:41:12 localhost kernel: [ 6053.712000] usb 1-1: new full speed
USB device using uhci_hcd and address 3
Feb 11 21:41:13 localhost kernel: [ 6053.860000] usb 1-1: configuration
#1 chosen from 1 choice
Feb 11 21:41:15 localhost kernel: [ 6056.592000] usb 1-1: USB
disconnect, address 3
Feb 11 21:41:15 localhost kernel: [ 6056.712000] usb 1-1: new full speed
USB device using uhci_hcd and address 4
Feb 11 21:41:16 localhost kernel: [ 6056.856000] usb 1-1: configuration
#1 chosen from 1 choice
Feb 11 21:41:19 localhost kernel: [ 6059.700000] usb 1-1: USB
disconnect, address 4
Feb 11 21:41:19 localhost kernel: [ 6059.812000] usb 1-1: new full speed
USB device using uhci_hcd and address 5
Feb 11 21:41:20 localhost kernel: [ 6059.960000] usb 1-1: configuration
#1 chosen from 1 choice
Feb 11 21:41:20 localhost kernel: [ 6060.204000] usb 1-1: USB
disconnect, address 5
Feb 11 21:41:20 localhost kernel: [ 6060.316000] usb 1-1: new full speed
USB device using uhci_hcd and address 6
Feb 11 21:41:20 localhost kernel: [ 6060.464000] usb 1-1: configuration
#1 chosen from 1 choice
Feb 11 21:41:21 localhost kernel: [ 6062.220000] usb 1-1: USB
disconnect, address 6
Feb 11 21:41:21 localhost kernel: [ 6062.332000] usb 1-1: new full speed
USB device using uhci_hcd and address 7
Feb 11 21:41:21 localhost kernel: [ 6062.480000] usb 1-1: configuration
#1 chosen from 1 choice
Feb 11 21:41:22 localhost kernel: [ 6062.724000] usb 1-1: USB
disconnect, address 7
Feb 11 21:41:22 localhost kernel: [ 6062.836000] usb 1-1: new full speed
USB device using uhci_hcd and address 8
Feb 11 21:41:22 localhost kernel: [ 6062.984000] usb 1-1: configuration
#1 chosen from 1 choice
Feb 11 21:41:22 localhost kernel: [ 6063.480000] usb 1-1: USB
disconnect, address 8
Feb 11 21:41:22 localhost kernel: [ 6063.592000] usb 1-1: new full speed
USB device using uhci_hcd and address 9
Feb 11 21:41:24 localhost kernel: [ 6064.452000] usb 1-1: new full speed
USB device using uhci_hcd and address 10
Feb 11 21:41:24 localhost kernel: [ 6065.012000] usb 1-1: new full speed
USB device using uhci_hcd and address 11
Feb 11 21:41:24 localhost kernel: [ 6065.532000] usb 1-1: new full speed
USB device using uhci_hcd and address 12
-------------
dmesg |grep usb :
[ 17.780000] usbcore: registered new interface driver usbfs
[ 17.784000] usbcore: registered new interface driver hub
[ 17.788000] usbcore: registered new device driver usb
[ 17.808000] usb usb1: configuration #1 chosen from 1 choice
[ 69.416000] usbcore: registered new interface driver ndiswrapper
[ 5916.300000] usbcore: deregistering interface driver ndiswrapper
[ 6049.104000] usb 1-1: new full speed USB device using uhci_hcd and
address 2
[ 6049.252000] usb 1-1: configuration #1 chosen from 1 choice
[ 6053.592000] usb 1-1: USB disconnect, address 2
[ 6053.712000] usb 1-1: new full speed USB device using uhci_hcd and
address 3
[ 6053.860000] usb 1-1: configuration #1 chosen from 1 choice
[ 6056.592000] usb 1-1: USB disconnect, address 3
[ 6056.712000] usb 1-1: new full speed USB device using uhci_hcd and
address 4
[ 6056.856000] usb 1-1: configuration #1 chosen from 1 choice
[ 6059.700000] usb 1-1: USB disconnect, address 4
[ 6059.812000] usb 1-1: new full speed USB device using uhci_hcd and
address 5
[ 6059.960000] usb 1-1: configuration #1 chosen from 1 choice
[ 6060.204000] usb 1-1: USB disconnect, address 5
[ 6060.316000] usb 1-1: new full speed USB device using uhci_hcd and
address 6
[ 6060.464000] usb 1-1: configuration #1 chosen from 1 choice
[ 6062.220000] usb 1-1: USB disconnect, address 6
[ 6062.332000] usb 1-1: new full speed USB device using uhci_hcd and
address 7
[ 6062.480000] usb 1-1: configuration #1 chosen from 1 choice
[ 6062.724000] usb 1-1: USB disconnect, address 7
[ 6062.836000] usb 1-1: new full speed USB device using uhci_hcd and
address 8
[ 6062.984000] usb 1-1: configuration #1 chosen from 1 choice
[ 6063.480000] usb 1-1: USB disconnect, address 8
[ 6063.592000] usb 1-1: new full speed USB device using uhci_hcd and
address 9
[ 6063.712000] usb 1-1: device descriptor read/64, error -71
[ 6064.340000] usb 1-1: device not accepting address 9, error -71
[ 6064.452000] usb 1-1: new full speed USB device using uhci_hcd and
address 10
[ 6064.572000] usb 1-1: device descriptor read/64, error -71
[ 6064.796000] usb 1-1: device descriptor read/64, error -71
[ 6065.012000] usb 1-1: new full speed USB device using uhci_hcd and
address 11
[ 6065.420000] usb 1-1: device not accepting address 11, error -71
[ 6065.532000] usb 1-1: new full speed USB device using uhci_hcd and
address 12
[ 6065.940000] usb 1-1: device not accepting address 12, error -71
----------------
End of the message
Am Sonntag, 11. Februar 2007 22:17 schrieb Thibaud Hulin:
> Hi !
>
> I'm trying to use a dongle for ndiswrapper, but it fails because a
> problem of usb. Note that the problem appear when ndiswrapper is fully
> uninstalled (and others packages as ndiswrapper-utils, with modprobe -r,
> etc...).
This report is valid only if ndiswrapper was never loaded from booting
to the error. Please post the report to [email protected]
and recompile your kernel with CONFIG_USB_DEBUG.
HTH
Oliver