I tried upgrading directly from 3.2.5 -> 3.4.4. Had two probs
(the one mentioned in this email, and inability to set MTU size
on the other card under 3.4.4). So, I thought to break it down --
first upgrading to current 3.2 (.22 at the time), then 3.3.6,
and then 3.4.4.
First was went to 3.2.22, which works (running it now)
Then I tried 3.3.6 -- ethernet related messages from bootlog are below
-- you can it finds the broadcom NetXtremeII cards and udev renames
the devs back according to it's rules, but NETRTLINK isn't seeing it.
These rename actions are the same under the current kernel and
stem from trying to keep device names constant over years of
HW changes -- i.e. they are normal
Note -- "ip link" lists the interface as "down" w/no address.. but try
bringing it up: NTRTLINK says interface not found...?
Any ideas on what might be causing this? I've combed over the options in
config(xconfig) at least 4 times now in detail and have tried variations
but don't see anything that could be causing this -- near as I can tell,
I'm booting with nearest config to my current as the new config allows.
But NTRTLINK isn't seeing the device?
Ideas? From the date of the driver it doesn't look like it has been
changed recently.
It's not good that the Intel card can no longer have it's packet size
set in 3.4 (i.e. network problems trending "worse")....
thanks,
-l
<6>[ 3.219112] bnx2: Broadcom NetXtreme II Gigabit Ethernet Driver
bnx2 v2.2.1 (Dec 18, 2011)
<6>[ 3.219930] bnx2 0000:01:00.0: eth0: Broadcom NetXtreme II BCM5709
1000Base-T (C0) PCI Express found at mem da000000, IRQ 36, node addr
00:26:b9:2c:a4:ef
<6>[ 3.220636] bnx2 0000:01:00.1: eth1: Broadcom NetXtreme II BCM5709
1000Base-T (C0) PCI Express found at mem dc000000, IRQ 48, node addr
00:26:b9:2c:a4:f1
e1000e: Intel(R) PRO/1000 Network Driver - 1.5.1-k
<6>[ 3.220691] e1000e: Copyright(c) 1999 - 2011 Intel Corporation.
<6>[ 3.220729] e1000e 0000:03:00.0: Disabling ASPM L1
<7>[ 3.220919] e1000e 0000:03:00.0: irq 89 for MSI/MSI-X
<6>[ 3.394181] e1000e 0000:03:00.0: eth2: (PCI Express:2.5GT/s:Width
x4) 00:15:17:bf:be:b2
<6>[ 3.394184] e1000e 0000:03:00.0: eth2: Intel(R) PRO/1000 Network
Connection
<6>[ 3.394301] e1000e 0000:03:00.0: eth2: MAC: 0, PHY: 4, PBA No:
C57721-005
<6>[ 3.394317] e1000e 0000:03:00.1: Disabling ASPM L1
<7>[ 3.394509] e1000e 0000:03:00.1: irq 90 for MSI/MSI-X
<6>[ 3.566803] e1000e 0000:03:00.1: eth3: (PCI Express:2.5GT/s:Width
x4) 00:15:17:bf:be:b3
<6>[ 3.566805] e1000e 0000:03:00.1: eth3: Intel(R) PRO/1000 Network
Connection
<6>[ 3.566881] e1000e 0000:03:00.1: eth3: MAC: 0, PHY: 4, PBA No:
C57721-005
<30>[ 6.389668] udevd[255]: renamed network interface eth1 to rename3
<30>[ 6.424537] udevd[232]: renamed network interface eth2 to rename4
<30>[ 6.444508] udevd[254]: renamed network interface eth0 to rename2
<30>[ 6.461477] udevd[255]: renamed network interface rename3 to eth3
<30>[ 6.496473] udevd[232]: renamed network interface rename4 to eth0
<30>[ 6.507422] udevd[254]: renamed network interface rename2 to eth2
Setting up (localfs) network interfaces:
lo
lo IP address: 127.0.0.1/8
done eth0 device: Intel Corporation 82571EB Gigabit Ethernet Co
eth0 IP address: 192.168.3.1/24
done eth1 device: Intel Corporation 82571EB Gigabit Ethernet Co
eth1 IP address: 192.168.3.129/24
done eth2 device: Broadcom Corporation NetXtreme II BCM5709 Gig
RTNETLINK answers: No such file or directory
Cannot enable interface eth2.
interface eth2 is not up
failed eth3 device: Broadcom Corporation NetXtreme II BCM5709 Gig
eth3 Startmode is 'off'
skippedWaiting for mandatory devices: eth2
26 25 24 23 22 21 19 18 17 16 15 14 13 11 10 9 8 7 6 4 3 2 1 0
eth2 device: Broadcom Corporation NetXtreme II BCM5709 Gig
eth2 is down
failed eth2 interface could not be set up until now
failedSetting up service (localfs) network . . . . . . . . .
.failed