Here, The function pdc_hardware_init always return zero. So it is not
necessary to check its return value. So make the function return void.
Fix these checkpatch.pl error:
ERROR: space prohibited after that '~' (ctx:WxW)
+ mask &= ~ (1 << (6 + ATA_SHIFT_UDMA));
ERROR: spaces required around that '?' (ctx:VxW)
+ long pout_required = board_idx? PDC_133_MHZ:PDC_100_MHZ;
ERROR: that open brace { should be on the previous line
+ const struct ata_port_info *ppi[] =
+ { &pdc2027x_port_info[board_idx], NULL };
Signed-off-by: Arvind Yadav <[email protected]>
---
changes in v2 :
Make function return type 'void' instead of 'int.
Add sapce between ':'.
drivers/ata/pata_pdc2027x.c | 18 +++++++-----------
1 file changed, 7 insertions(+), 11 deletions(-)
diff --git a/drivers/ata/pata_pdc2027x.c b/drivers/ata/pata_pdc2027x.c
index ffd8d33..d1e8b63 100644
--- a/drivers/ata/pata_pdc2027x.c
+++ b/drivers/ata/pata_pdc2027x.c
@@ -277,7 +277,7 @@ static unsigned long pdc2027x_mode_filter(struct ata_device *adev, unsigned long
ATA_ID_PROD_LEN + 1);
/* If the master is a maxtor in UDMA6 then the slave should not use UDMA 6 */
if (strstr(model_num, "Maxtor") == NULL && pair->dma_mode == XFER_UDMA_6)
- mask &= ~ (1 << (6 + ATA_SHIFT_UDMA));
+ mask &= ~(1 << (6 + ATA_SHIFT_UDMA));
return mask;
}
@@ -520,7 +520,7 @@ static void pdc_adjust_pll(struct ata_host *host, long pll_clock, unsigned int b
void __iomem *mmio_base = host->iomap[PDC_MMIO_BAR];
u16 pll_ctl;
long pll_clock_khz = pll_clock / 1000;
- long pout_required = board_idx? PDC_133_MHZ:PDC_100_MHZ;
+ long pout_required = board_idx ? PDC_133_MHZ : PDC_100_MHZ;
long ratio = pout_required / pll_clock_khz;
int F, R;
@@ -649,7 +649,7 @@ static long pdc_detect_pll_input_clock(struct ata_host *host)
* @host: target ATA host
* @board_idx: board identifier
*/
-static int pdc_hardware_init(struct ata_host *host, unsigned int board_idx)
+static void pdc_hardware_init(struct ata_host *host, unsigned int board_idx)
{
long pll_clock;
@@ -665,8 +665,6 @@ static int pdc_hardware_init(struct ata_host *host, unsigned int board_idx)
/* Adjust PLL control register */
pdc_adjust_pll(host, pll_clock, board_idx);
-
- return 0;
}
/**
@@ -707,8 +705,8 @@ static int pdc2027x_init_one(struct pci_dev *pdev,
static const unsigned long cmd_offset[] = { 0x17c0, 0x15c0 };
static const unsigned long bmdma_offset[] = { 0x1000, 0x1008 };
unsigned int board_idx = (unsigned int) ent->driver_data;
- const struct ata_port_info *ppi[] =
- { &pdc2027x_port_info[board_idx], NULL };
+ const struct ata_port_info *ppi[] = {
+ &pdc2027x_port_info[board_idx], NULL };
struct ata_host *host;
void __iomem *mmio_base;
int i, rc;
@@ -753,8 +751,7 @@ static int pdc2027x_init_one(struct pci_dev *pdev,
//pci_enable_intx(pdev);
/* initialize adapter */
- if (pdc_hardware_init(host, board_idx) != 0)
- return -EIO;
+ pdc_hardware_init(host, board_idx);
pci_set_master(pdev);
return ata_host_activate(host, pdev->irq, ata_bmdma_interrupt,
@@ -778,8 +775,7 @@ static int pdc2027x_reinit_one(struct pci_dev *pdev)
else
board_idx = PDC_UDMA_133;
- if (pdc_hardware_init(host, board_idx))
- return -EIO;
+ pdc_hardware_init(host, board_idx);
ata_host_resume(host);
return 0;
--
2.7.4
From 1584962079579995499@xxx Fri Nov 24 15:33:47 +0000 2017
X-GM-THRID: 1584962079579995499
X-Gmail-Labels: Inbox,Category Forums,HistoricalUnread