On 07/11/2023 20:00, Kalra, Ashish wrote:
> Hello Boris,
>
> Addressing of some of the remaining comments:
>
> On 11/7/2023 10:31 AM, Borislav Petkov wrote:
>> On Mon, Oct 16, 2023 at 08:27:35AM -0500, Michael Roth wrote:
>>> +static bool early_rmptable_check(void)
>>> +{
>>> + u64 rmp_base, rmp_size;
>>> +
>>> + /*
>>> + * For early BSP initialization, max_pfn won't be set up yet, wait until
>>> + * it is set before performing the RMP table calculations.
>>> + */
>>> + if (!max_pfn)
>>> + return true;
>>
>> This already says that this is called at the wrong point during init.
>>
>> Right now we have
>>
>> early_identify_cpu -> early_init_amd -> early_detect_mem_encrypt
>>
>> which runs only on the BSP but then early_init_amd() is called in
>> init_amd() too so that it takes care of the APs too.
>>
>> Which ends up doing a lot of unnecessary work on each AP in
>> early_detect_mem_encrypt() like calculating the RMP size on each AP
>> unnecessarily where this needs to happen exactly once.
>>
>> Is there any reason why this function cannot be moved to init_amd()
>> where it'll do the normal, per-AP init?
>>
>> And the stuff that needs to happen once, needs to be called once too.
>>
>>> +
>>> + return snp_get_rmptable_info(&rmp_base, &rmp_size);
>>> +}
>>> +
>>> static void early_detect_mem_encrypt(struct cpuinfo_x86 *c)
>>> {
>>> u64 msr;
>>> @@ -659,6 +674,9 @@ static void early_detect_mem_encrypt(struct cpuinfo_x86 *c)
>>> if (!(msr & MSR_K7_HWCR_SMMLOCK))
>>> goto clear_sev;
>>> + if (cpu_has(c, X86_FEATURE_SEV_SNP) && !early_rmptable_check())
>>> + goto clear_snp;
>>> +
>>> return;
>>> clear_all:
>>> @@ -666,6 +684,7 @@ static void early_detect_mem_encrypt(struct cpuinfo_x86 *c)
>>> clear_sev:
>>> setup_clear_cpu_cap(X86_FEATURE_SEV);
>>> setup_clear_cpu_cap(X86_FEATURE_SEV_ES);
>>> +clear_snp:
>>> setup_clear_cpu_cap(X86_FEATURE_SEV_SNP);
>>> }
>>> }
>>
>> ...
>>
>>> +bool snp_get_rmptable_info(u64 *start, u64 *len)
>>> +{
>>> + u64 max_rmp_pfn, calc_rmp_sz, rmp_sz, rmp_base, rmp_end;
>>> +
>>> + rdmsrl(MSR_AMD64_RMP_BASE, rmp_base);
>>> + rdmsrl(MSR_AMD64_RMP_END, rmp_end);
>>> +
>>> + if (!(rmp_base & RMP_ADDR_MASK) || !(rmp_end & RMP_ADDR_MASK)) {
>>> + pr_err("Memory for the RMP table has not been reserved by BIOS\n");
>>> + return false;
>>> + }
>>
>> If you're masking off bits 0-12 above...
>>
>>> +
>>> + if (rmp_base > rmp_end) {
>>
>> ... why aren't you using the masked out vars further on?
>>
>> I know, the hw will say, yeah, those bits are 0 but still. IOW, do:
>>
>> rmp_base &= RMP_ADDR_MASK;
>> rmp_end &= RMP_ADDR_MASK;
>>
>> after reading them.
>>
>>> + pr_err("RMP configuration not valid: base=%#llx, end=%#llx\n", rmp_base, rmp_end);
>>> + return false;
>>> + }
>>> +
>>> + rmp_sz = rmp_end - rmp_base + 1;
>>> +
>>> + /*
>>> + * Calculate the amount the memory that must be reserved by the BIOS to
>>> + * address the whole RAM, including the bookkeeping area. The RMP itself
>>> + * must also be covered.
>>> + */
>>> + max_rmp_pfn = max_pfn;
>>> + if (PHYS_PFN(rmp_end) > max_pfn)
>>> + max_rmp_pfn = PHYS_PFN(rmp_end);
>>> +
>>> + calc_rmp_sz = (max_rmp_pfn << 4) + RMPTABLE_CPU_BOOKKEEPING_SZ;
>>> +
>>> + if (calc_rmp_sz > rmp_sz) {
>>> + pr_err("Memory reserved for the RMP table does not cover full system RAM (expected 0x%llx got 0x%llx)\n",
>>> + calc_rmp_sz, rmp_sz);
>>> + return false;
>>> + }
>>> +
>>> + *start = rmp_base;
>>> + *len = rmp_sz;
>>> +
>>> + return true;
>>> +}
>>> +
>>> +static __init int __snp_rmptable_init(void)
>>> +{
>>> + u64 rmp_base, rmp_size;
>>> + void *rmp_start;
>>> + u64 val;
>>> +
>>> + if (!snp_get_rmptable_info(&rmp_base, &rmp_size))
>>> + return 1;
>>> +
>>> + pr_info("RMP table physical address [0x%016llx - 0x%016llx]\n",
>>
>> That's "RMP table physical range"
>>
>>> + rmp_base, rmp_base + rmp_size - 1);
>>> +
>>> + rmp_start = memremap(rmp_base, rmp_size, MEMREMAP_WB);
>>> + if (!rmp_start) {
>>> + pr_err("Failed to map RMP table addr 0x%llx size 0x%llx\n", rmp_base, rmp_size);
>>
>> No need to dump rmp_base and rmp_size again here - you're dumping them
>> above.
>>
>>> + return 1;
>>> + }
>>> +
>>> + /*
>>> + * Check if SEV-SNP is already enabled, this can happen in case of
>>> + * kexec boot.
>>> + */
>>> + rdmsrl(MSR_AMD64_SYSCFG, val);
>>> + if (val & MSR_AMD64_SYSCFG_SNP_EN)
>>> + goto skip_enable;
>>> +
>>> + /* Initialize the RMP table to zero */
>>
>> Again: useless comment.
>>
>>> + memset(rmp_start, 0, rmp_size);
>>> +
>>> + /* Flush the caches to ensure that data is written before SNP is enabled. */
>>> + wbinvd_on_all_cpus();
>>> +
>>> + /* MFDM must be enabled on all the CPUs prior to enabling SNP. */
>>
>> First of all, use the APM bit name here pls: MtrrFixDramModEn.
>>
>> And then, for the life of me, I can't find any mention in the APM why
>> this bit is needed. Neither in "15.36.2 Enabling SEV-SNP" nor in
>> "15.34.3 Enabling SEV".
>>
>> Looking at the bit defintions of WrMem an RdMem - read and write
>> requests get directed to system memory instead of MMIO so I guess you
>> don't want to be able to write MMIO for certain physical ranges when SNP
>> is enabled but it'll be good to have this properly explained instead of
>> a "this must happen" information-less sentence.
>
> This is a per-requisite for SNP_INIT as per the SNP Firmware ABI specifications, section 8.8.2:
>
> From the SNP FW ABI specs:
>
> If INIT_RMP is 1, then the firmware ensures the following system requirements are met:
> • SYSCFG[MemoryEncryptionModEn] must be set to 1 across all cores. (SEV must be
> enabled.)> • SYSCFG[SecureNestedPagingEn] must be set to 1 across all cores.
> • SYSCFG[VMPLEn] must be set to 1 across all cores.
> • SYSCFG[MFDM] must be set to 1 across all cores.
Hi Ashish,
I just noticed that the kernel shouts at me about this bit when I offline->online a CPU in
an SNP host:
[2692586.589194] smpboot: CPU 63 is now offline
[2692589.366822] [Firmware Warn]: MTRR: CPU 0: SYSCFG[MtrrFixDramModEn] not cleared by BIOS, clearing this bit
[2692589.376582] smpboot: Booting Node 0 Processor 63 APIC 0x3f
[2692589.378070] [Firmware Warn]: MTRR: CPU 63: SYSCFG[MtrrFixDramModEn] not cleared by BIOS, clearing this bit
[2692589.388845] microcode: CPU63: new patch_level=0x0a0011d1
Now I understand if you say "CPU offlining is not supported" but there's nothing currently
blocking it.
Best wishes,
Jeremi
> • VM_HSAVE_PA (MSR C001_0117) must be set to 0h across all cores.
> • HWCR[SmmLock] (MSR C001_0015) must be set to 1 across all cores.
>
> So, this platform enabling code for SNP needs to ensure that these conditions are met before SNP_INIT is called.
>