The OPP core finds the eventual frequency to set with the help of
clk_round_rate() and the same was earlier getting passed to _set_opp()
and that's what would get configured.
The commit 1efae8d2e777 ("OPP: Make dev_pm_opp_set_opp() independent of
frequency") mistakenly changed that. Fix it.
Fixes: 1efae8d2e777 ("OPP: Make dev_pm_opp_set_opp() independent of frequency")
Cc: v5.18+ <[email protected]> # v6.0+
Signed-off-by: Viresh Kumar <[email protected]>
---
drivers/opp/core.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/opp/core.c b/drivers/opp/core.c
index 29f8160c3e38..5e6cfcbd2e87 100644
--- a/drivers/opp/core.c
+++ b/drivers/opp/core.c
@@ -1352,12 +1352,12 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
* value of the frequency. In such a case, do not abort but
* configure the hardware to the desired frequency forcefully.
*/
- forced = opp_table->rate_clk_single != target_freq;
+ forced = opp_table->rate_clk_single != freq;
}
- ret = _set_opp(dev, opp_table, opp, &target_freq, forced);
+ ret = _set_opp(dev, opp_table, opp, &freq, forced);
- if (target_freq)
+ if (freq)
dev_pm_opp_put(opp);
put_opp_table:
--
2.31.1.272.g89b43f80a514