Commit 50d8f87d2b3 (powerpc/fsl-pci Make PCIe hotplug work with Freescale
PCIe controllers) does not handle non-PCIe controllers properly, which causes
a panic during boot for certain configurations.
This patch fixes the issue by calling setup_indirect_pci for all device types.
fsl_indirect_read_config is now only used for booke/86xx PCIe controllers.
Reported-by: Michael Guntsche <[email protected]>
Cc: Scott Wood <[email protected]>
Signed-off-by: Rojhalat Ibrahim <[email protected]>
---
v3: Fix compile error
arch/powerpc/sysdev/fsl_pci.c | 24 +++++++++---------------
1 file changed, 9 insertions(+), 15 deletions(-)
diff --git a/arch/powerpc/sysdev/fsl_pci.c b/arch/powerpc/sysdev/fsl_pci.c
index 028ac1f..46ac1dd 100644
--- a/arch/powerpc/sysdev/fsl_pci.c
+++ b/arch/powerpc/sysdev/fsl_pci.c
@@ -97,22 +97,14 @@ static int fsl_indirect_read_config(struct pci_bus *bus, unsigned int devfn,
return indirect_read_config(bus, devfn, offset, len, val);
}
-static struct pci_ops fsl_indirect_pci_ops =
+#if defined(CONFIG_FSL_SOC_BOOKE) || defined(CONFIG_PPC_86xx)
+
+static struct pci_ops fsl_indirect_pcie_ops =
{
.read = fsl_indirect_read_config,
.write = indirect_write_config,
};
-static void __init fsl_setup_indirect_pci(struct pci_controller* hose,
- resource_size_t cfg_addr,
- resource_size_t cfg_data, u32 flags)
-{
- setup_indirect_pci(hose, cfg_addr, cfg_data, flags);
- hose->ops = &fsl_indirect_pci_ops;
-}
-
-#if defined(CONFIG_FSL_SOC_BOOKE) || defined(CONFIG_PPC_86xx)
-
#define MAX_PHYS_ADDR_BITS 40
static u64 pci64_dma_offset = 1ull << MAX_PHYS_ADDR_BITS;
@@ -504,13 +496,15 @@ int __init fsl_add_bridge(struct platform_device *pdev, int is_primary)
if (!hose->private_data)
goto no_bridge;
- fsl_setup_indirect_pci(hose, rsrc.start, rsrc.start + 0x4,
- PPC_INDIRECT_TYPE_BIG_ENDIAN);
+ setup_indirect_pci(hose, rsrc.start, rsrc.start + 0x4,
+ PPC_INDIRECT_TYPE_BIG_ENDIAN);
if (in_be32(&pci->block_rev1) < PCIE_IP_REV_3_0)
hose->indirect_type |= PPC_INDIRECT_TYPE_FSL_CFG_REG_LINK;
if (early_find_capability(hose, 0, 0, PCI_CAP_ID_EXP)) {
+ /* use fsl_indirect_read_config for PCIe */
+ hose->ops = &fsl_indirect_pcie_ops;
/* For PCIE read HEADER_TYPE to identify controler mode */
early_read_config_byte(hose, 0, 0, PCI_HEADER_TYPE, &hdr_type);
if ((hdr_type & 0x7f) != PCI_HEADER_TYPE_BRIDGE)
@@ -814,8 +808,8 @@ int __init mpc83xx_add_bridge(struct device_node *dev)
if (ret)
goto err0;
} else {
- fsl_setup_indirect_pci(hose, rsrc_cfg.start,
- rsrc_cfg.start + 4, 0);
+ setup_indirect_pci(hose, rsrc_cfg.start,
+ rsrc_cfg.start + 4, 0);
}
printk(KERN_INFO "Found FSL PCI host bridge at 0x%016llx. "
--
1.8.1.5