The MV64XXX hardware can act as either a bus controller or target
device. In order to protect target devices from a glitching bus
(apparently), the core listens on the lines even when idle and moves the
hardware FSM to the "BUS_ERR" state if an invalid transition is
detected. The hardware then does not exit this state until reset.
This feature is actually counterproductive when using the hardware as a
controller (as this driver does): we do not actually *care* what
happened on the bus previously, as long as it's ready for use when the
new transfer starts. However, the controller will remember a previous
glitch and trip up the driver after it attempts to send the start
command. The driver logs and error and resets the controller, recovering
from the BUS_ERR state, but not without erroring back the transfer with
errno EAGAIN. Clients generally do not handle this gracefully.
This is easily fixed by checking for the BUS_ERR condition upfront and
issuing the hardware reset before beginning the transfer. This patch
does NOT also call i2c_recover_bus(): the assumption is that the bus is
fine, just the hardware is upset; if the bus is also in a bad state,
this should not pass silently.
Signed-off-by: Sam Edwards <[email protected]>
---
drivers/i2c/busses/i2c-mv64xxx.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/i2c/busses/i2c-mv64xxx.c
b/drivers/i2c/busses/i2c-mv64xxx.c
index fd8403b07fa6..cfc16909fba3 100644
--- a/drivers/i2c/busses/i2c-mv64xxx.c
+++ b/drivers/i2c/busses/i2c-mv64xxx.c
@@ -753,6 +753,7 @@ mv64xxx_i2c_xfer_core(struct i2c_adapter *adap,
struct i2c_msg msgs[], int num)
{
struct mv64xxx_i2c_data *drv_data = i2c_get_adapdata(adap);
int rc, ret = num;
+ u32 status;
rc = pm_runtime_resume_and_get(&adap->dev);
if (rc)
@@ -762,6 +763,11 @@ mv64xxx_i2c_xfer_core(struct i2c_adapter *adap,
struct i2c_msg msgs[], int num)
drv_data->msgs = msgs;
drv_data->num_msgs = num;
+ /* Calm down the hardware if it was upset by a bus glitch while idle */
+ status = readl(drv_data->reg_base + drv_data->reg_offsets.status);
+ if (status == MV64XXX_I2C_STATUS_BUS_ERR)
+ mv64xxx_i2c_hw_init(drv_data);
+
if (mv64xxx_i2c_can_offload(drv_data) && !drv_data->atomic)
rc = mv64xxx_i2c_offload_xfer(drv_data);
else
--
2.43.2