Hi all,
I've written an ethernet driver for ENC28J60, a stand-alone ethernet
controller with a SPI interface, in Rust.
It works fine on Raspberry Pi 4B with Raspbian AArch64.
You can connect to the internet and play some videos on YouTube with it
(10BASE-T though).
I hope it will be an example of real-world drivers in Rust.
* ENC28J60 ethernet driver in Rust
enc28j60rs: https://github.com/pfpacket/enc28j60rs
`impl Sync/Send`, mostly because of raw pointers, and the initialization
of `workqueue::Work` and `sync::Spinlock`
require a tiny bit of "unsafe" code, but otherwise no unsafe code used.
* The forked kernel with Rust support for SPI and netdev
https://github.com/pfpacket/linux-rpi-rust/tree/rust-netdev
Forked from the Raspberry Pi tree and merged Rust-for-Linux `rust`
branch into it.
(BTW are there any easier way to get Rust-for-Linux work on Raspberry
Pi? If so please let me know.)
Then I added the SPI support referencing rust/kernel/platform.rs and
netdev support.
The netdev support is based on the following GitHub PR from Fujita-san:
https://github.com/Rust-for-Linux/linux/pull/908
Regards,
Ryo Munakata
Ryo Munakata <[email protected]> writes:
> Hi all,
>
> I've written an ethernet driver for ENC28J60, a stand-alone ethernet controller
> with a SPI interface, in Rust.
> It works fine on Raspberry Pi 4B with Raspbian AArch64.
> You can connect to the internet and play some videos on YouTube with it
> (10BASE-T though).
> I hope it will be an example of real-world drivers in Rust.
>
> * ENC28J60 ethernet driver in Rust
> enc28j60rs: https://github.com/pfpacket/enc28j60rs
> `impl Sync/Send`, mostly because of raw pointers, and the initialization of
> `workqueue::Work` and `sync::Spinlock`
> require a tiny bit of "unsafe" code, but otherwise no unsafe code used.
>
> * The forked kernel with Rust support for SPI and netdev
> https://github.com/pfpacket/linux-rpi-rust/tree/rust-netdev
> Forked from the Raspberry Pi tree and merged Rust-for-Linux `rust` branch into
> it.
> (BTW are there any easier way to get Rust-for-Linux work on Raspberry Pi? If so
> please let me know.)
> Then I added the SPI support referencing rust/kernel/platform.rs and netdev
> support.
> The netdev support is based on the following GitHub PR from Fujita-san:
> https://github.com/Rust-for-Linux/linux/pull/908
This is cool, thanks! I will check it out at some point.
Best regards
Andreas Hindborg