[ Resending to the right mailing list. I looked up in MAINTAINERS, but
forgot to run "git bisect reset" and got the wrong address for
dri-devel@. Apologies to all who receive this twice. ]
After upgrading to 2.6.35-rc5, I noticed that my monitor reports a
refresh rate of 60 Hz when nouveau.ko is loaded, rather than the 75 Hz I
got on 2.6.34. Graphics card is an NV86 (GeForce 8500 GT), the monitor
is a 1280x1024 TFT (Yakumo 19AL) connected via VGA.
I bisected this to the following commit:
--8<---------------cut here---------------start------------->8---
commit c867df7043b738da4f4d358d7039c243a29b4272
Author: Adam Jackson <[email protected]>
Date: Mon Mar 29 21:43:21 2010 +0000
drm/edid: Reshuffle mode list construction to closer match the spec
Also, document what the spec says to do.
Signed-off-by: Adam Jackson <[email protected]>
Signed-off-by: Dave Airlie <[email protected]>
diff --git a/drivers/gpu/drm/drm_edid.c b/drivers/gpu/drm/drm_edid.c
index 9c4717f..858fedc 100644
--- a/drivers/gpu/drm/drm_edid.c
+++ b/drivers/gpu/drm/drm_edid.c
@@ -1377,10 +1377,24 @@ int drm_add_edid_modes(struct drm_connector *connector, struct edid *edid)
quirks = edid_get_quirks(edid);
- num_modes += add_established_modes(connector, edid);
- num_modes += add_standard_modes(connector, edid);
+ /*
+ * EDID spec says modes should be preferred in this order:
+ * - preferred detailed mode
+ * - other detailed modes from base block
+ * - detailed modes from extension blocks
+ * - CVT 3-byte code modes
+ * - standard timing codes
+ * - established timing codes
+ * - modes inferred from GTF or CVT range information
+ *
+ * We don't quite implement this yet, but we're close.
+ *
+ * XXX order for additional mode types in extension blocks?
+ */
num_modes += add_detailed_info(connector, edid, quirks);
num_modes += add_detailed_info_eedid(connector, edid, quirks);
+ num_modes += add_standard_modes(connector, edid);
+ num_modes += add_established_modes(connector, edid);
if (quirks & (EDID_QUIRK_PREFER_LARGE_60 | EDID_QUIRK_PREFER_LARGE_75))
edid_fixup_preferred(connector, quirks);
--8<---------------cut here---------------end--------------->8---
How do I get the 75 Hz refresh rate back? Adding "video=1280x1024@75"
as described in the nouveau wiki? has no effect.
Regards,
Sven
? http://nouveau.freedesktop.org/wiki/KernelModeSetting