I just set up a new system with an Asus P4P800 and P4 with HT. Under
2.4.23-pre4 the system freezes occasionally for a few seconds, sometimes for
as long as a minute. Then it recovers as if nothing happened. No printks,
nothing to explain what happened. When the machine is frozen it doesn't
respond to pings, but when it recovers it sends all the icmp echo responses
for the time it was down.
At first I thought it was related to the i810_audio, since it seemed to happen
consistently whenever I started playing a new track in xmms. But I've removed
the i810_audio module and it's still happening.
I thought it could be related to the sk98 ethernet driver even though I wasn't
using it but i've removed that module too. I haven't rebooted since removing
these modules though.
The only "suspicious" things left are Hyperthreading, and the SATA controller.
Have other people been reporting similar problems?
--
greg
Greg Stark <[email protected]> writes:
> I just set up a new system with an Asus P4P800 and P4 with HT. Under
> 2.4.23-pre4 the system freezes occasionally for a few seconds, sometimes for
> as long as a minute. Then it recovers as if nothing happened. No printks,
I think I've identified a culprit. Kind of. There are three drives in the
machine, one old 7G Quantum, an 80G Maxtor, (both on the same IDE channel),
and a new SATA maxtor. Whenever noflushd has the 80G Maxtor spun down I get
these freezes randomly. Not when it's spinning down, it happens randomly any
time while the drive is spun down.
In fact the whole spin-down spin-up sequence doesn't seem to work right at
all. Under older kernels the drive started spinning up immediately whenever it
was accessed. Under this kernel the drive doesn't even start audibly spinning
up for a long time, like 10s or so. Then I see errors in dmesg like the ones
below. Note that the problems still occur even once dma is disabled, though
they seem less severe. For some reason the problem only seems related to the
Maxtor, not the Quantum.
hdb: dma_timer_expiry: dma status == 0x61
hdb: error waiting for DMA
hdb: dma timeout retry: status=0xd0 { Busy }
hda: DMA disabled
hdb: DMA disabled
ide0: reset: success
blk: queue c035a268, I/O limit 4095Mb (mask 0xffffffff)
wait_on_irq, CPU 1:
irq: 0 [ 1 0 ]
bh: 1 [ 1 0 ]
Stack dumps:
CPU 0: <unknown>
CPU 1:f7ed3f28 00000001 00000001 ffffffff 00000080 c0109e18 c02653a4 00000001
f4d2d000 c0108ff2 00000001 00000001 c01bcbd7 c0118a86 d9776000 c0349a14
00000000 f4d2d168 c02a65c4 f7ed3f88 00000000 f7ed2000 c0121cba f4d2d000
Call Trace: [<c0109e18>] [<c0108ff2>] [<c01bcbd7>] [<c0118a86>] [<c0121cba>]
[<c012ae5e>] [<c012ac80>] [<c0105000>] [<c010592e>] [<c012ac80>]
hdb: dma_timer_expiry: dma status == 0x41
hdb: error waiting for DMA
hdb: dma timeout retry: status=0xd0 { Busy }
hdb: DMA disabled
ide0: reset: success
--
greg