Hi,
This series contains two patches for spi-mt65xx.c, both focusing on its
interrupt handler mtk_spi_interrupt().
The first patch is to fix a NULL pointer access in the interrupt
handler, which is first found on a MT8186 Chromebook device when the
system tries to establish host communication with its embedded
controller.
The second one is a decorative clean-up when I'm working on the first
patch, which simply renames a variable to better follow the rest of the
code.
I put this after the first fix because I think that will make
maintainers and users slightly easier to only backport the fix if
needed.
Looking forward to any feedback, thank you.
Regards,
Fei
Fei Shao (2):
spi: spi-mt65xx: Fix NULL pointer access in interrupt handler
spi: spi-mt65xx: Rename a variable in interrupt handler
drivers/spi/spi-mt65xx.c | 47 ++++++++++++++++++++--------------------
1 file changed, 23 insertions(+), 24 deletions(-)
--
2.44.0.396.g6e790dbe36-goog
The TX buffer in spi_transfer can be a NULL pointer, so the interrupt
handler may end up writing to the invalid memory and cause crashes.
Add a check to xfer->tx_buf before using it.
Fixes: 1ce24864bff4 ("spi: mediatek: Only do dma for 4-byte aligned buffers")
Signed-off-by: Fei Shao <[email protected]>
---
drivers/spi/spi-mt65xx.c | 21 +++++++++++----------
1 file changed, 11 insertions(+), 10 deletions(-)
diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
index 8d4633b353ee..86ea822c942b 100644
--- a/drivers/spi/spi-mt65xx.c
+++ b/drivers/spi/spi-mt65xx.c
@@ -788,17 +788,18 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
mdata->xfer_len = min(MTK_SPI_MAX_FIFO_SIZE, len);
mtk_spi_setup_packet(host);
- cnt = mdata->xfer_len / 4;
- iowrite32_rep(mdata->base + SPI_TX_DATA_REG,
- trans->tx_buf + mdata->num_xfered, cnt);
+ if (trans->tx_buf) {
+ cnt = mdata->xfer_len / 4;
+ iowrite32_rep(mdata->base + SPI_TX_DATA_REG,
+ trans->tx_buf + mdata->num_xfered, cnt);
- remainder = mdata->xfer_len % 4;
- if (remainder > 0) {
- reg_val = 0;
- memcpy(®_val,
- trans->tx_buf + (cnt * 4) + mdata->num_xfered,
- remainder);
- writel(reg_val, mdata->base + SPI_TX_DATA_REG);
+ remainder = mdata->xfer_len % 4;
+ if (remainder > 0) {
+ reg_val = 0;
+ memcpy(®_val,
+ trans->tx_buf + (cnt * 4) + mdata->num_xfered,
+ remainder);
+ writel(reg_val, mdata->base + SPI_TX_DATA_REG);
}
mtk_spi_enable_transfer(host);
--
2.44.0.396.g6e790dbe36-goog
All the spi_transfer variables in this file use the name "xfer" except
the one in mtk_spi_interrupt(). Align the naming for consistency and
easier searching.
While at it, reformat one memcpy() usage since the coding style allows
100 column lines today.
This commit has no functional change.
Signed-off-by: Fei Shao <[email protected]>
---
drivers/spi/spi-mt65xx.c | 32 +++++++++++++++-----------------
1 file changed, 15 insertions(+), 17 deletions(-)
diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
index 86ea822c942b..aaa0006a02a3 100644
--- a/drivers/spi/spi-mt65xx.c
+++ b/drivers/spi/spi-mt65xx.c
@@ -748,7 +748,7 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
u32 cmd, reg_val, cnt, remainder, len;
struct spi_controller *host = dev_id;
struct mtk_spi *mdata = spi_controller_get_devdata(host);
- struct spi_transfer *trans = mdata->cur_transfer;
+ struct spi_transfer *xfer = mdata->cur_transfer;
reg_val = readl(mdata->base + SPI_STATUS0_REG);
if (reg_val & MTK_SPI_PAUSE_INT_STATUS)
@@ -762,42 +762,40 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
return IRQ_HANDLED;
}
- if (!host->can_dma(host, NULL, trans)) {
- if (trans->rx_buf) {
+ if (!host->can_dma(host, NULL, xfer)) {
+ if (xfer->rx_buf) {
cnt = mdata->xfer_len / 4;
ioread32_rep(mdata->base + SPI_RX_DATA_REG,
- trans->rx_buf + mdata->num_xfered, cnt);
+ xfer->rx_buf + mdata->num_xfered, cnt);
remainder = mdata->xfer_len % 4;
if (remainder > 0) {
reg_val = readl(mdata->base + SPI_RX_DATA_REG);
- memcpy(trans->rx_buf +
- mdata->num_xfered +
- (cnt * 4),
+ memcpy(xfer->rx_buf + (cnt * 4) + mdata->num_xfered,
®_val,
remainder);
}
}
mdata->num_xfered += mdata->xfer_len;
- if (mdata->num_xfered == trans->len) {
+ if (mdata->num_xfered == xfer->len) {
spi_finalize_current_transfer(host);
return IRQ_HANDLED;
}
- len = trans->len - mdata->num_xfered;
+ len = xfer->len - mdata->num_xfered;
mdata->xfer_len = min(MTK_SPI_MAX_FIFO_SIZE, len);
mtk_spi_setup_packet(host);
- if (trans->tx_buf) {
+ if (xfer->tx_buf) {
cnt = mdata->xfer_len / 4;
iowrite32_rep(mdata->base + SPI_TX_DATA_REG,
- trans->tx_buf + mdata->num_xfered, cnt);
+ xfer->tx_buf + mdata->num_xfered, cnt);
remainder = mdata->xfer_len % 4;
if (remainder > 0) {
reg_val = 0;
memcpy(®_val,
- trans->tx_buf + (cnt * 4) + mdata->num_xfered,
+ xfer->tx_buf + (cnt * 4) + mdata->num_xfered,
remainder);
writel(reg_val, mdata->base + SPI_TX_DATA_REG);
}
@@ -808,21 +806,21 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
}
if (mdata->tx_sgl)
- trans->tx_dma += mdata->xfer_len;
+ xfer->tx_dma += mdata->xfer_len;
if (mdata->rx_sgl)
- trans->rx_dma += mdata->xfer_len;
+ xfer->rx_dma += mdata->xfer_len;
if (mdata->tx_sgl && (mdata->tx_sgl_len == 0)) {
mdata->tx_sgl = sg_next(mdata->tx_sgl);
if (mdata->tx_sgl) {
- trans->tx_dma = sg_dma_address(mdata->tx_sgl);
+ xfer->tx_dma = sg_dma_address(mdata->tx_sgl);
mdata->tx_sgl_len = sg_dma_len(mdata->tx_sgl);
}
}
if (mdata->rx_sgl && (mdata->rx_sgl_len == 0)) {
mdata->rx_sgl = sg_next(mdata->rx_sgl);
if (mdata->rx_sgl) {
- trans->rx_dma = sg_dma_address(mdata->rx_sgl);
+ xfer->rx_dma = sg_dma_address(mdata->rx_sgl);
mdata->rx_sgl_len = sg_dma_len(mdata->rx_sgl);
}
}
@@ -840,7 +838,7 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
mtk_spi_update_mdata_len(host);
mtk_spi_setup_packet(host);
- mtk_spi_setup_dma_addr(host, trans);
+ mtk_spi_setup_dma_addr(host, xfer);
mtk_spi_enable_transfer(host);
return IRQ_HANDLED;
--
2.44.0.396.g6e790dbe36-goog
On Thu, Mar 21, 2024 at 2:43 PM Fei Shao <[email protected]> wrote:
>
> Hi,
>
> This series contains two patches for spi-mt65xx.c, both focusing on its
> interrupt handler mtk_spi_interrupt().
>
> The first patch is to fix a NULL pointer access in the interrupt
> handler, which is first found on a MT8186 Chromebook device when the
> system tries to establish host communication with its embedded
> controller.
>
> The second one is a decorative clean-up when I'm working on the first
> patch, which simply renames a variable to better follow the rest of the
> code.
> I put this after the first fix because I think that will make
> maintainers and users slightly easier to only backport the fix if
> needed.
>
> Looking forward to any feedback, thank you.
>
> Regards,
> Fei
Sorry, I found I messed things up in the last rebase and this doesn't compile.
I'll send a v2 soon so please disregard this series.
Regards,
Fei
>
>
> Fei Shao (2):
> spi: spi-mt65xx: Fix NULL pointer access in interrupt handler
> spi: spi-mt65xx: Rename a variable in interrupt handler
>
> drivers/spi/spi-mt65xx.c | 47 ++++++++++++++++++++--------------------
> 1 file changed, 23 insertions(+), 24 deletions(-)
>
> --
> 2.44.0.396.g6e790dbe36-goog
>