Hi,
On Thu, Nov 30, 2017 at 3:27 AM, Daniel Thompson
<[email protected]> wrote:
>
>
> On 30/11/17 00:44, Doug Anderson wrote:
>>
>> Hi,
>>
>> On Thu, Nov 16, 2017 at 6:11 AM, Enric Balletbo i Serra
>> <[email protected]> wrote:
>>>
>>> When you want to change the brightness using a PWM signal, one thing you
>>> need to consider is how human perceive the brightness. Human perceive the
>>> brightness change non-linearly, we have better sensitivity at low
>>> luminance than high luminance, so to achieve perceived linear dimming,
>>> the
>>> brightness must be matches to the way our eyes behave. The CIE 1931
>>> lightness formula is what actually describes how we perceive light.
>>>
>>> This patch adds support to compute the brightness levels based on a
>>> static
>>> table filled with the numbers provided by the CIE 1931 algorithm, for now
>>> it only supports PWM resolutions up to 65535 (16 bits) with 1024 steps.
>>> Lower PWM resolutions are implemented using the same curve but with less
>>> steps, e.g. For a PWM resolution of 256 (8 bits) we have 37 steps.
>>
>>
>> Your patch assumes that the input to your formula (luminance, I think)
>> scales linearly with PWM duty cycle. I don't personally know this,
>> but has anyone confirmed it's common in reality, or at least is a
>> close enough approximation of reality?
>
>
> Isn't this the loop we went round for v1?
>
> We do know that its not linear, however the graphs from a couple of example
> devices didn't look too scary and nobody has proposed a better formula.
>
> At this point the linear interpolation code in patch 1 allows people with
> especially alinear devices to express suitable brightness curves.
>
> However we also know that many DT authors choose not to create good
> brightness tables for their devices... and we'd rather they used allowed the
> kernel to choose a model than to use no model at all.
OK, cool. I didn't remember anyone actually confirming that they had
checked that this was the case, but that's probably just my bad memory
and failures at searching through history. I don't have any
objections to the idea if people are convinced it's a good enough
approximation. :)
It would be kinda nice if something could go in the commit message, like:
This method will work in any cases where linearly scaling the PWM duty
cycle causes a roughly linear scaling of the luminance of the
backlight.
:)
-Doug
From 1585490271072406728@xxx Thu Nov 30 11:29:10 +0000 2017
X-GM-THRID: 1584241125376833263
X-Gmail-Labels: Inbox,Category Forums,HistoricalUnread