On Thu, Jun 6, 2024 at 3:19 PM Andreas Kemnade <[email protected]> wrote:
>
> Hi Luiz,
>
> On Thu, 6 Jun 2024 16:04:10 -0400
> Luiz Augusto von Dentz <[email protected]> wrote:
>
> > Hi Andreas,
> >
> > On Thu, Jun 6, 2024 at 2:30 PM Andreas Kemnade <[email protected]> wrote:
> > >
> > > Some of these chips have GNSS support. In some vendor kernels
> > > a driver on top of misc/ti-st can be found providing a /dev/tigps
> > > device which speaks the secretive Air Independent Interface (AI2) protocol.
I think you may have sent me a file to test, but I can't find the
e-mail. Can you tell me what tool you used to test it? I can get
gnss0 to enumerate, so I am close.
[ 20.759857] hci-ti serial0-0: using DT
'/ocp@68000000/serial@4806c000/bluetooth-gnss' for 'enable' GPIO
lookup
[ 20.770263] of_get_named_gpiod_flags: parsed 'enable-gpios'
property of node '/ocp@68000000/serial@4806c000/bluetooth-gnss[0]' -
status (0)
[ 29.221588] gnss: GNSS driver registered with major 244
adam
> > >
> > > To be more compatible with userspace send out NMEA by default but
> > > allow a more raw mode by using a module parameter.
> > >
> > > This was tested on the Epson Moverio BT-200.
> > >
> > > Who will take this series (1-3)? GNSS with ack from Bluetooth?
> > >
> > > Changes since V3:
> > > - Finally remove the period from 1/4 subject
> > > - include things directly for get_unaligned_le16() to fix 0-day issues
> > >
> > > Changes since V2:
> > > - Optimize waits
> > > - Fix some packet analysis / checksum computation issue
> > > - Adding a proposal for removing those waits as RFC
> > > - Minor spell corrections and improved descriptions
> > >
> > > Changes since V1:
> > > - Set up things for NMEA output
> > > - Powerup/down at open()/close()
> > > - split out logic between drivers/bluetooth and drivers/gnss
> > > - leave out drivers/misc/ti-st driver removal to avoid
> > > filling up mailboxes during the iterations, this series is
> > > still a proof that it is not needed, will take the brush after
> > > this series is accepted.
> > >
> > >
> > > Andreas Kemnade (4):
> > > gnss: Add AI2 protocol used by some TI combo chips
> > > Bluetooth: ti-st: Add GNSS subdevice for TI Wilink chips
> >
> > The bluetooth one looks relatively simple so I could take that one and
> > push to bluetooth-next if there are no dependencies on the other
> > changes.
> >
> There is:
>
> include/linux/ti_wilink_st.h | 8 +
>
> We have compile time deps here. Patch 3 compile time depends on patch 2. If we
> cannot take everything in for 6.11, you might opt to take the bluetooth part.
> That would work.
>
> Regards,
> Andreas