From: Bartosz Golaszewski <[email protected]>
CONFIG_DEBUG_GPIO should only be used to enable debug log messages and
for core GPIOLIB debugging. Don't use it to control the execution of
potentially buggy code. Just put it under an always-false #if.
Signed-off-by: Bartosz Golaszewski <[email protected]>
---
drivers/gpio/gpio-tps65219.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)
diff --git a/drivers/gpio/gpio-tps65219.c b/drivers/gpio/gpio-tps65219.c
index 7b38aa360112..cd1f17041f8c 100644
--- a/drivers/gpio/gpio-tps65219.c
+++ b/drivers/gpio/gpio-tps65219.c
@@ -96,16 +96,16 @@ static int tps65219_gpio_change_direction(struct gpio_chip *gc, unsigned int off
* Below can be used for test purpose only.
*/
- if (IS_ENABLED(CONFIG_DEBUG_GPIO)) {
- int ret = regmap_update_bits(gpio->tps->regmap, TPS65219_REG_MFP_1_CONFIG,
- TPS65219_GPIO0_DIR_MASK, direction);
- if (ret) {
- dev_err(dev,
- "GPIO DEBUG enabled: Fail to change direction to %u for GPIO%d.\n",
- direction, offset);
- return ret;
- }
+#if 0
+ int ret = regmap_update_bits(gpio->tps->regmap, TPS65219_REG_MFP_1_CONFIG,
+ TPS65219_GPIO0_DIR_MASK, direction);
+ if (ret) {
+ dev_err(dev,
+ "GPIO DEBUG enabled: Fail to change direction to %u for GPIO%d.\n",
+ direction, offset);
+ return ret;
}
+#endif
dev_err(dev,
"GPIO%d direction set by NVM, change to %u failed, not allowed by specification\n",
--
2.40.1
On Thu, Dec 21, 2023 at 8:57 PM Bartosz Golaszewski <[email protected]> wrote:
>
> From: Bartosz Golaszewski <[email protected]>
>
> CONFIG_DEBUG_GPIO should only be used to enable debug log messages and
> for core GPIOLIB debugging. Don't use it to control the execution of
> potentially buggy code. Just put it under an always-false #if.
Reviewed-by: Andy Shevchenko <[email protected]>
--
With Best Regards,
Andy Shevchenko
On Thu, Dec 21, 2023 at 7:57 PM Bartosz Golaszewski <[email protected]> wrote:
> From: Bartosz Golaszewski <[email protected]>
>
> CONFIG_DEBUG_GPIO should only be used to enable debug log messages and
> for core GPIOLIB debugging. Don't use it to control the execution of
> potentially buggy code. Just put it under an always-false #if.
>
> Signed-off-by: Bartosz Golaszewski <[email protected]>
Maybe I would have simply deleted the code, but OK. I bet some static
analyzers will promptly return complaints about "no #if 0 in the kernel" :/
In this case it's an OK compromise.
Acked-by: Linus Walleij <[email protected]>
Yours,
Linus Walleij
On Thu, Dec 21, 2023 at 7:57 PM Bartosz Golaszewski <[email protected]> wrote:
>
> From: Bartosz Golaszewski <[email protected]>
>
> CONFIG_DEBUG_GPIO should only be used to enable debug log messages and
> for core GPIOLIB debugging. Don't use it to control the execution of
> potentially buggy code. Just put it under an always-false #if.
>
> Signed-off-by: Bartosz Golaszewski <[email protected]>
> ---
> drivers/gpio/gpio-tps65219.c | 18 +++++++++---------
> 1 file changed, 9 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/gpio/gpio-tps65219.c b/drivers/gpio/gpio-tps65219.c
> index 7b38aa360112..cd1f17041f8c 100644
> --- a/drivers/gpio/gpio-tps65219.c
> +++ b/drivers/gpio/gpio-tps65219.c
> @@ -96,16 +96,16 @@ static int tps65219_gpio_change_direction(struct gpio_chip *gc, unsigned int off
> * Below can be used for test purpose only.
> */
>
> - if (IS_ENABLED(CONFIG_DEBUG_GPIO)) {
> - int ret = regmap_update_bits(gpio->tps->regmap, TPS65219_REG_MFP_1_CONFIG,
> - TPS65219_GPIO0_DIR_MASK, direction);
> - if (ret) {
> - dev_err(dev,
> - "GPIO DEBUG enabled: Fail to change direction to %u for GPIO%d.\n",
> - direction, offset);
> - return ret;
> - }
> +#if 0
> + int ret = regmap_update_bits(gpio->tps->regmap, TPS65219_REG_MFP_1_CONFIG,
> + TPS65219_GPIO0_DIR_MASK, direction);
> + if (ret) {
> + dev_err(dev,
> + "GPIO DEBUG enabled: Fail to change direction to %u for GPIO%d.\n",
> + direction, offset);
> + return ret;
> }
> +#endif
>
> dev_err(dev,
> "GPIO%d direction set by NVM, change to %u failed, not allowed by specification\n",
> --
> 2.40.1
>
Patch applied.
Bart