2019-10-09 21:35:27

by Jeffrey Hugo

[permalink] [raw]
Subject: [PATCH] drm/msm/dsi: Implement reset correctly

On msm8998, vblank timeouts are observed because the DSI controller is not
reset properly, which ends up stalling the MDP. This is because the reset
logic is not correct per the hardware documentation.

The documentation states that after asserting reset, software should wait
some time (no indication of how long), or poll the status register until it
returns 0 before deasserting reset.

wmb() is insufficient for this purpose since it just ensures ordering, not
timing between writes. Since asserting and deasserting reset occurs on the
same register, ordering is already guaranteed by the architecture, making
the wmb extraneous.

Since we would define a timeout for polling the status register to avoid a
possible infinite loop, lets just use a static delay of 20 ms, since 16.666
ms is the time available to process one frame at 60 fps.

Fixes: a689554ba6ed (drm/msm: Initial add DSI connector support)
Signed-off-by: Jeffrey Hugo <[email protected]>
---

Rob et al, is it possible for this to go into a 5.4-rc?

drivers/gpu/drm/msm/dsi/dsi_host.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
index 663ff9f4fac9..68ded9b4735d 100644
--- a/drivers/gpu/drm/msm/dsi/dsi_host.c
+++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
@@ -986,7 +986,7 @@ static void dsi_sw_reset(struct msm_dsi_host *msm_host)
wmb(); /* clocks need to be enabled before reset */

dsi_write(msm_host, REG_DSI_RESET, 1);
- wmb(); /* make sure reset happen */
+ msleep(20); /* make sure reset happen */
dsi_write(msm_host, REG_DSI_RESET, 0);
}

@@ -1396,7 +1396,7 @@ static void dsi_sw_reset_restore(struct msm_dsi_host *msm_host)

/* dsi controller can only be reset while clocks are running */
dsi_write(msm_host, REG_DSI_RESET, 1);
- wmb(); /* make sure reset happen */
+ msleep(20); /* make sure reset happen */
dsi_write(msm_host, REG_DSI_RESET, 0);
wmb(); /* controller out of reset */
dsi_write(msm_host, REG_DSI_CTRL, data0);
--
2.17.1


2019-10-10 18:48:08

by Sean Paul

[permalink] [raw]
Subject: Re: [PATCH] drm/msm/dsi: Implement reset correctly

On Wed, Oct 09, 2019 at 02:34:54PM -0700, Jeffrey Hugo wrote:
> On msm8998, vblank timeouts are observed because the DSI controller is not
> reset properly, which ends up stalling the MDP. This is because the reset
> logic is not correct per the hardware documentation.
>
> The documentation states that after asserting reset, software should wait
> some time (no indication of how long), or poll the status register until it
> returns 0 before deasserting reset.
>
> wmb() is insufficient for this purpose since it just ensures ordering, not
> timing between writes. Since asserting and deasserting reset occurs on the
> same register, ordering is already guaranteed by the architecture, making
> the wmb extraneous.
>
> Since we would define a timeout for polling the status register to avoid a
> possible infinite loop, lets just use a static delay of 20 ms, since 16.666
> ms is the time available to process one frame at 60 fps.
>
> Fixes: a689554ba6ed (drm/msm: Initial add DSI connector support)
> Signed-off-by: Jeffrey Hugo <[email protected]>
> ---
>
> Rob et al, is it possible for this to go into a 5.4-rc?
>
> drivers/gpu/drm/msm/dsi/dsi_host.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
> index 663ff9f4fac9..68ded9b4735d 100644
> --- a/drivers/gpu/drm/msm/dsi/dsi_host.c
> +++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
> @@ -986,7 +986,7 @@ static void dsi_sw_reset(struct msm_dsi_host *msm_host)
> wmb(); /* clocks need to be enabled before reset */
>
> dsi_write(msm_host, REG_DSI_RESET, 1);
> - wmb(); /* make sure reset happen */
> + msleep(20); /* make sure reset happen */

Could you please pull this out into a #define used for both in case we decide to
tweak it? I don't want these 2 values to drift.

Thanks,
Sean

> dsi_write(msm_host, REG_DSI_RESET, 0);
> }
>
> @@ -1396,7 +1396,7 @@ static void dsi_sw_reset_restore(struct msm_dsi_host *msm_host)
>
> /* dsi controller can only be reset while clocks are running */
> dsi_write(msm_host, REG_DSI_RESET, 1);
> - wmb(); /* make sure reset happen */
> + msleep(20); /* make sure reset happen */
> dsi_write(msm_host, REG_DSI_RESET, 0);
> wmb(); /* controller out of reset */
> dsi_write(msm_host, REG_DSI_CTRL, data0);
> --
> 2.17.1
>

--
Sean Paul, Software Engineer, Google / Chromium OS

2019-10-10 18:50:07

by Sean Paul

[permalink] [raw]
Subject: Re: [PATCH] drm/msm/dsi: Implement reset correctly

On Thu, Oct 10, 2019 at 2:45 PM Sean Paul <[email protected]> wrote:
>
> On Wed, Oct 09, 2019 at 02:34:54PM -0700, Jeffrey Hugo wrote:
> > On msm8998, vblank timeouts are observed because the DSI controller is not
> > reset properly, which ends up stalling the MDP. This is because the reset
> > logic is not correct per the hardware documentation.
> >
> > The documentation states that after asserting reset, software should wait
> > some time (no indication of how long), or poll the status register until it
> > returns 0 before deasserting reset.
> >
> > wmb() is insufficient for this purpose since it just ensures ordering, not
> > timing between writes. Since asserting and deasserting reset occurs on the
> > same register, ordering is already guaranteed by the architecture, making
> > the wmb extraneous.
> >
> > Since we would define a timeout for polling the status register to avoid a
> > possible infinite loop, lets just use a static delay of 20 ms, since 16.666
> > ms is the time available to process one frame at 60 fps.
> >
> > Fixes: a689554ba6ed (drm/msm: Initial add DSI connector support)
> > Signed-off-by: Jeffrey Hugo <[email protected]>
> > ---
> >
> > Rob et al, is it possible for this to go into a 5.4-rc?

Sorry, I missed this on the first go-around, I'm Ok with this getting
into 5.4. Rob, if you're Ok with this, I can send it through -misc
unless you're planning an msm-fixes PR.

> >
> > drivers/gpu/drm/msm/dsi/dsi_host.c | 4 ++--
> > 1 file changed, 2 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
> > index 663ff9f4fac9..68ded9b4735d 100644
> > --- a/drivers/gpu/drm/msm/dsi/dsi_host.c
> > +++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
> > @@ -986,7 +986,7 @@ static void dsi_sw_reset(struct msm_dsi_host *msm_host)
> > wmb(); /* clocks need to be enabled before reset */
> >
> > dsi_write(msm_host, REG_DSI_RESET, 1);
> > - wmb(); /* make sure reset happen */
> > + msleep(20); /* make sure reset happen */
>
> Could you please pull this out into a #define used for both in case we decide to
> tweak it? I don't want these 2 values to drift.
>

oh yeah, and with that fixed,

Reviewed-by: Sean Paul <[email protected]>

> Thanks,
> Sean
>
> > dsi_write(msm_host, REG_DSI_RESET, 0);
> > }
> >
> > @@ -1396,7 +1396,7 @@ static void dsi_sw_reset_restore(struct msm_dsi_host *msm_host)
> >
> > /* dsi controller can only be reset while clocks are running */
> > dsi_write(msm_host, REG_DSI_RESET, 1);
> > - wmb(); /* make sure reset happen */
> > + msleep(20); /* make sure reset happen */
> > dsi_write(msm_host, REG_DSI_RESET, 0);
> > wmb(); /* controller out of reset */
> > dsi_write(msm_host, REG_DSI_CTRL, data0);
> > --
> > 2.17.1
> >
>
> --
> Sean Paul, Software Engineer, Google / Chromium OS

2019-10-10 19:01:04

by Jeffrey Hugo

[permalink] [raw]
Subject: Re: [PATCH] drm/msm/dsi: Implement reset correctly

On Thu, Oct 10, 2019 at 12:49 PM Sean Paul <[email protected]> wrote:
>
> On Thu, Oct 10, 2019 at 2:45 PM Sean Paul <[email protected]> wrote:
> >
> > On Wed, Oct 09, 2019 at 02:34:54PM -0700, Jeffrey Hugo wrote:
> > > On msm8998, vblank timeouts are observed because the DSI controller is not
> > > reset properly, which ends up stalling the MDP. This is because the reset
> > > logic is not correct per the hardware documentation.
> > >
> > > The documentation states that after asserting reset, software should wait
> > > some time (no indication of how long), or poll the status register until it
> > > returns 0 before deasserting reset.
> > >
> > > wmb() is insufficient for this purpose since it just ensures ordering, not
> > > timing between writes. Since asserting and deasserting reset occurs on the
> > > same register, ordering is already guaranteed by the architecture, making
> > > the wmb extraneous.
> > >
> > > Since we would define a timeout for polling the status register to avoid a
> > > possible infinite loop, lets just use a static delay of 20 ms, since 16.666
> > > ms is the time available to process one frame at 60 fps.
> > >
> > > Fixes: a689554ba6ed (drm/msm: Initial add DSI connector support)
> > > Signed-off-by: Jeffrey Hugo <[email protected]>
> > > ---
> > >
> > > Rob et al, is it possible for this to go into a 5.4-rc?
>
> Sorry, I missed this on the first go-around, I'm Ok with this getting
> into 5.4. Rob, if you're Ok with this, I can send it through -misc
> unless you're planning an msm-fixes PR.
>
> > >
> > > drivers/gpu/drm/msm/dsi/dsi_host.c | 4 ++--
> > > 1 file changed, 2 insertions(+), 2 deletions(-)
> > >
> > > diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
> > > index 663ff9f4fac9..68ded9b4735d 100644
> > > --- a/drivers/gpu/drm/msm/dsi/dsi_host.c
> > > +++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
> > > @@ -986,7 +986,7 @@ static void dsi_sw_reset(struct msm_dsi_host *msm_host)
> > > wmb(); /* clocks need to be enabled before reset */
> > >
> > > dsi_write(msm_host, REG_DSI_RESET, 1);
> > > - wmb(); /* make sure reset happen */
> > > + msleep(20); /* make sure reset happen */
> >
> > Could you please pull this out into a #define used for both in case we decide to
> > tweak it? I don't want these 2 values to drift.
> >

Oh, yeah. That's a really good point. Will fix.

>
> oh yeah, and with that fixed,
>
> Reviewed-by: Sean Paul <[email protected]>

Thanks.

>
> > Thanks,
> > Sean
> >
> > > dsi_write(msm_host, REG_DSI_RESET, 0);
> > > }
> > >
> > > @@ -1396,7 +1396,7 @@ static void dsi_sw_reset_restore(struct msm_dsi_host *msm_host)
> > >
> > > /* dsi controller can only be reset while clocks are running */
> > > dsi_write(msm_host, REG_DSI_RESET, 1);
> > > - wmb(); /* make sure reset happen */
> > > + msleep(20); /* make sure reset happen */
> > > dsi_write(msm_host, REG_DSI_RESET, 0);
> > > wmb(); /* controller out of reset */
> > > dsi_write(msm_host, REG_DSI_CTRL, data0);
> > > --
> > > 2.17.1
> > >
> >
> > --
> > Sean Paul, Software Engineer, Google / Chromium OS