Hi,
one of my friends uses 2.2.18-pre21 (packaged by Debian...) and
when he run tripwire, he got:
iput: device 08:07 inode 47215 still has aliases!
iput: device 08:07 inode 47592 still has aliases!
iput: device 08:07 inode 110279 still has aliases!
iput: device 08:02 inode 62928 still has aliases!
iput: device 08:02 inode 34036 still has aliases!
iput: device 08:02 inode 33863 still has aliases!
iput: device 08:02 inode 3518 still has aliases!
iput: device 08:02 inode 64494 still has aliases!
iput: device 08:02 inode 62928 still has aliases!
iput: device 08:02 inode 109302 still has aliases!
iput: device 08:02 inode 34834 still has aliases!
iput: device 08:02 inode 33928 still has aliases!
iput: device 08:02 inode 16601 still has aliases!
iput: device 08:02 inode 3333 still has aliases!
iput: device 08:02 inode 107577 still has aliases!
iput: device 08:02 inode 2457 still has aliases!
iput: device 08:02 inode 16908 still has aliases!
iput: device 08:02 inode 95410 still has aliases!
iput: device 08:02 inode 110990 still has aliases!
iput: device 08:02 inode 78678 still has aliases!
iput: device 08:02 inode 30685 still has aliases!
iput: inode 08:02/30685 count wrapped
Filesystem 1k-blocks Used Available Use% Mounted on
/dev/sda2 964532 487668 427868 53% /
/dev/sda1 31077 2103 27370 7% /boot
/dev/sda6 482217 13 457305 0% /tmp
/dev/sda7 2213668 147208 1954008 7% /var
Abit BE6-II, one year old, both of these devices are ext2.
00:00.0 Host bridge: Intel Corporation 440BX/ZX - 82443BX/ZX Host bridge (rev 03)
00:01.0 PCI bridge: Intel Corporation 440BX/ZX - 82443BX/ZX AGP bridge (rev 03)
00:07.0 ISA bridge: Intel Corporation 82371AB PIIX4 ISA (rev 02)
00:07.1 IDE interface: Intel Corporation 82371AB PIIX4 IDE (rev 01)
00:07.2 USB Controller: Intel Corporation 82371AB PIIX4 USB (rev 01)
00:07.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 02)
00:0f.0 SCSI storage controller: Adaptec 7892A (rev 02)
00:11.0 Ethernet controller: Digital Equipment Corporation DECchip 21140 [FasterNet] (rev 22)
(scsi0) <Adaptec AIC-7892 Ultra 160/m SCSI host adapter> found at PCI
0/15/0
(scsi0) Wide Channel, SCSI ID=7, 32/255 SCBs
(scsi0) Downloading sequencer code... 392 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.31/3.2.4
<Adaptec AIC-7892 Ultra 160/m SCSI host adapter>
scsi : 1 host.
(scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 15.
Vendor: WDIGTL Model: ENTERPRISE Rev: 1.80
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
scsi : detected 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 8515173 [4157 MB] [4.2
GB]
Partition check:
sda: sda1 sda2 sda3 < sda5 sda6 sda7 >
When he rerun 'tripwire' (witout reboot), he was awarded by
iput: inode 00:00/0 count wrapped
Tripwire itself finished without any complaints.
Thanks,
Petr Vandrovec
[email protected]