2019-07-31 10:02:22

by Anil Joy Varughese

[permalink] [raw]
Subject: [PATCH] scsi: ufs: Additional clock initialization in Cadence UFS

Configure CDNS_UFS_REG_HCLKDIV in .hce_enable_notify()
because if UFSHCD resets the controller ip because of
phy or device related errors then CDNS_UFS_REG_HCLKDIV
is reset to default value and .setup_clock() is not
called later in the sequence whereas hce_enable_notify
will be called everytime controller is reenabled.

Signed-off-by: Anil Varughese <[email protected]>
---
drivers/scsi/ufs/cdns-pltfrm.c | 18 ++++++++++++++++++
1 file changed, 18 insertions(+)

diff --git a/drivers/scsi/ufs/cdns-pltfrm.c b/drivers/scsi/ufs/cdns-pltfrm.c
index 86dbb723f..15ee54d28 100644
--- a/drivers/scsi/ufs/cdns-pltfrm.c
+++ b/drivers/scsi/ufs/cdns-pltfrm.c
@@ -78,6 +78,22 @@ static int cdns_ufs_setup_clocks(struct ufs_hba *hba, bool on,
return cdns_ufs_set_hclkdiv(hba);
}

+/**
+ * Called before and after HCE enable bit is set.
+ * @hba: host controller instance
+ * @status: notify stage (pre, post change)
+ *
+ * Return zero for success and non-zero for failure
+ */
+static int cdns_ufs_hce_enable_notify(struct ufs_hba *hba,
+ enum ufs_notify_change_status status)
+{
+ if (status != PRE_CHANGE)
+ return 0;
+
+ return cdns_ufs_set_hclkdiv(hba);
+}
+
/**
* cdns_ufs_init - performs additional ufs initialization
* @hba: host controller instance
@@ -115,12 +131,14 @@ static int cdns_ufs_m31_16nm_phy_initialization(struct ufs_hba *hba)
static const struct ufs_hba_variant_ops cdns_ufs_pltfm_hba_vops = {
.name = "cdns-ufs-pltfm",
.setup_clocks = cdns_ufs_setup_clocks,
+ .hce_enable_notify = cdns_ufs_hce_enable_notify,
};

static const struct ufs_hba_variant_ops cdns_ufs_m31_16nm_pltfm_hba_vops = {
.name = "cdns-ufs-pltfm",
.init = cdns_ufs_init,
.setup_clocks = cdns_ufs_setup_clocks,
+ .hce_enable_notify = cdns_ufs_hce_enable_notify,
.phy_initialization = cdns_ufs_m31_16nm_phy_initialization,
};

--
2.15.0


2019-07-31 12:29:50

by Avri Altman

[permalink] [raw]
Subject: RE: [PATCH] scsi: ufs: Additional clock initialization in Cadence UFS

>
> Configure CDNS_UFS_REG_HCLKDIV in .hce_enable_notify()
> because if UFSHCD resets the controller ip because of
> phy or device related errors then CDNS_UFS_REG_HCLKDIV
> is reset to default value and .setup_clock() is not
> called later in the sequence whereas hce_enable_notify
> will be called everytime controller is reenabled.
>
> Signed-off-by: Anil Varughese <[email protected]>
Reviewed-by: Avri Altman <[email protected]>

2019-07-31 17:41:47

by Vignesh Raghavendra

[permalink] [raw]
Subject: Re: [PATCH] scsi: ufs: Additional clock initialization in Cadence UFS

Hi,

On 31-Jul-19 2:06 PM, Anil Varughese wrote:
> Configure CDNS_UFS_REG_HCLKDIV in .hce_enable_notify()
> because if UFSHCD resets the controller ip because of
> phy or device related errors then CDNS_UFS_REG_HCLKDIV
> is reset to default value and .setup_clock() is not
> called later in the sequence whereas hce_enable_notify
> will be called everytime controller is reenabled.
>
So, now that CDNS_UFS_REG_HCLKDIV is configured in .hce_enable_notify(),
is it still required to have the same code in .setup_clock() as well?
Isn't setting up CDNS_UFS_REG_HCLKDIV in .hce_enable_notify() alone not
sufficient?

Regards
Vignesh

> Signed-off-by: Anil Varughese <[email protected]>
> ---
> drivers/scsi/ufs/cdns-pltfrm.c | 18 ++++++++++++++++++
> 1 file changed, 18 insertions(+)
>
> diff --git a/drivers/scsi/ufs/cdns-pltfrm.c b/drivers/scsi/ufs/cdns-pltfrm.c
> index 86dbb723f..15ee54d28 100644
> --- a/drivers/scsi/ufs/cdns-pltfrm.c
> +++ b/drivers/scsi/ufs/cdns-pltfrm.c
> @@ -78,6 +78,22 @@ static int cdns_ufs_setup_clocks(struct ufs_hba *hba, bool on,
> return cdns_ufs_set_hclkdiv(hba);
> }
>
> +/**
> + * Called before and after HCE enable bit is set.
> + * @hba: host controller instance
> + * @status: notify stage (pre, post change)
> + *
> + * Return zero for success and non-zero for failure
> + */
> +static int cdns_ufs_hce_enable_notify(struct ufs_hba *hba,
> + enum ufs_notify_change_status status)
> +{
> + if (status != PRE_CHANGE)
> + return 0;
> +
> + return cdns_ufs_set_hclkdiv(hba);
> +}
> +
> /**
> * cdns_ufs_init - performs additional ufs initialization
> * @hba: host controller instance
> @@ -115,12 +131,14 @@ static int cdns_ufs_m31_16nm_phy_initialization(struct ufs_hba *hba)
> static const struct ufs_hba_variant_ops cdns_ufs_pltfm_hba_vops = {
> .name = "cdns-ufs-pltfm",
> .setup_clocks = cdns_ufs_setup_clocks,
> + .hce_enable_notify = cdns_ufs_hce_enable_notify,
> };
>
> static const struct ufs_hba_variant_ops cdns_ufs_m31_16nm_pltfm_hba_vops = {
> .name = "cdns-ufs-pltfm",
> .init = cdns_ufs_init,
> .setup_clocks = cdns_ufs_setup_clocks,
> + .hce_enable_notify = cdns_ufs_hce_enable_notify,
> .phy_initialization = cdns_ufs_m31_16nm_phy_initialization,
> };
>
>

2019-08-01 13:19:13

by Anil Joy Varughese

[permalink] [raw]
Subject: RE: [PATCH] scsi: ufs: Additional clock initialization in Cadence UFS

Hi Vignesh,

You are correct I have tested the code here and .setup_clock is not needed anymore; CDNS_UFS_REG_HCLKDIV configured in .hce_enable_notify() is enough. I will fix this in patch v2.

Thanks,
Anil

-----Original Message-----
From: Vignesh Raghavendra <[email protected]>
Sent: Wednesday, July 31, 2019 10:05 PM
To: Anil Joy Varughese <[email protected]>; [email protected]; [email protected]; [email protected]
Cc: [email protected]; [email protected]; [email protected]; Rafal Ciepiela <[email protected]>; Milind Parab <[email protected]>; Jan Kotas <[email protected]>; [email protected]; [email protected]
Subject: Re: [PATCH] scsi: ufs: Additional clock initialization in Cadence UFS

EXTERNAL MAIL


Hi,

On 31-Jul-19 2:06 PM, Anil Varughese wrote:
> Configure CDNS_UFS_REG_HCLKDIV in .hce_enable_notify() because if
> UFSHCD resets the controller ip because of phy or device related
> errors then CDNS_UFS_REG_HCLKDIV is reset to default value and
> .setup_clock() is not called later in the sequence whereas
> hce_enable_notify will be called everytime controller is reenabled.
>
So, now that CDNS_UFS_REG_HCLKDIV is configured in .hce_enable_notify(), is it still required to have the same code in .setup_clock() as well?
Isn't setting up CDNS_UFS_REG_HCLKDIV in .hce_enable_notify() alone not sufficient?

Regards
Vignesh

> Signed-off-by: Anil Varughese <[email protected]>
> ---
> drivers/scsi/ufs/cdns-pltfrm.c | 18 ++++++++++++++++++
> 1 file changed, 18 insertions(+)
>
> diff --git a/drivers/scsi/ufs/cdns-pltfrm.c
> b/drivers/scsi/ufs/cdns-pltfrm.c index 86dbb723f..15ee54d28 100644
> --- a/drivers/scsi/ufs/cdns-pltfrm.c
> +++ b/drivers/scsi/ufs/cdns-pltfrm.c
> @@ -78,6 +78,22 @@ static int cdns_ufs_setup_clocks(struct ufs_hba *hba, bool on,
> return cdns_ufs_set_hclkdiv(hba);
> }
>
> +/**
> + * Called before and after HCE enable bit is set.
> + * @hba: host controller instance
> + * @status: notify stage (pre, post change)
> + *
> + * Return zero for success and non-zero for failure */ static int
> +cdns_ufs_hce_enable_notify(struct ufs_hba *hba,
> + enum ufs_notify_change_status status) {
> + if (status != PRE_CHANGE)
> + return 0;
> +
> + return cdns_ufs_set_hclkdiv(hba);
> +}
> +
> /**
> * cdns_ufs_init - performs additional ufs initialization
> * @hba: host controller instance
> @@ -115,12 +131,14 @@ static int
> cdns_ufs_m31_16nm_phy_initialization(struct ufs_hba *hba) static const struct ufs_hba_variant_ops cdns_ufs_pltfm_hba_vops = {
> .name = "cdns-ufs-pltfm",
> .setup_clocks = cdns_ufs_setup_clocks,
> + .hce_enable_notify = cdns_ufs_hce_enable_notify,
> };
>
> static const struct ufs_hba_variant_ops cdns_ufs_m31_16nm_pltfm_hba_vops = {
> .name = "cdns-ufs-pltfm",
> .init = cdns_ufs_init,
> .setup_clocks = cdns_ufs_setup_clocks,
> + .hce_enable_notify = cdns_ufs_hce_enable_notify,
> .phy_initialization = cdns_ufs_m31_16nm_phy_initialization,
> };
>
>