From: albanhuang <[email protected]>
The 16550a serial port based on the ACPI table requires obtaining the
reg-shift attribute. In the ACPI scenario, If the reg-shift property
is not configured like in DTS, the 16550a serial driver cannot read or
write controller registers properly during initialization.
Signed-off-by: albanhuang <[email protected]>
Signed-off-by: tombinfan <[email protected]>
Signed-off-by: dylanlhdu <[email protected]>
---
drivers/tty/serial/8250/8250_pnp.c | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/tty/serial/8250/8250_pnp.c b/drivers/tty/serial/8250/8250_pnp.c
index 1974bbadc975..25b4e41e9745 100644
--- a/drivers/tty/serial/8250/8250_pnp.c
+++ b/drivers/tty/serial/8250/8250_pnp.c
@@ -473,6 +473,7 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
uart.port.flags |= UPF_SHARE_IRQ;
uart.port.uartclk = 1843200;
device_property_read_u32(&dev->dev, "clock-frequency", &uart.port.uartclk);
+ device_property_read_u8(&dev->dev, "reg-shift", &uart.port.regshift);
uart.port.dev = &dev->dev;
line = serial8250_register_8250_port(&uart);
--
2.17.1