Usually, We only need to print the error log when there is a PCIe card but
initialization fails. Whether the driver finds the PCIe card or not is the
expected behavior. So it's better to log these information with dev_info().
Tested on MT7628AN router Motorola MWR03.
Signed-off-by: Shiji Yang <[email protected]>
---
arch/mips/pci/pci-mt7620.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/mips/pci/pci-mt7620.c b/arch/mips/pci/pci-mt7620.c
index df3347643..5c4bdf691 100644
--- a/arch/mips/pci/pci-mt7620.c
+++ b/arch/mips/pci/pci-mt7620.c
@@ -327,7 +327,7 @@ static int mt7620_pci_probe(struct platform_device *pdev)
rt_sysc_m32(RALINK_PCIE0_CLK_EN, 0, RALINK_CLKCFG1);
if (ralink_soc == MT762X_SOC_MT7620A)
rt_sysc_m32(LC_CKDRVPD, PDRV_SW_SET, PPLL_DRV);
- dev_err(&pdev->dev, "PCIE0 no card, disable it(RST&CLK)\n");
+ dev_info(&pdev->dev, "PCIE0 no card, disable it(RST&CLK)\n");
return -1;
}
@@ -370,7 +370,7 @@ int pcibios_map_irq(const struct pci_dev *dev, u8 slot, u8 pin)
dev->bus->number, slot);
return 0;
}
- dev_err(&dev->dev, "card - bus=0x%x, slot = 0x%x irq=%d\n",
+ dev_info(&dev->dev, "card - bus=0x%x, slot = 0x%x irq=%d\n",
dev->bus->number, slot, irq);
/* configure the cache line size to 0x14 */
--
2.30.2