Hi Rob, Nicolin
>
> Hi Rob
> >
> > On Wed, Oct 30, 2019 at 07:41:26PM +0800, Shengjiu Wang wrote:
> > > In order to support the two asrc modules in imx8qm, we need to add
> > > compatible string "fsl,imx8qm-asrc0" and "fsl,imx8qm-asrc1"
> >
> > Are the blocks different in some way?
> >
> > If not, why do you need to distinguish them?
> >
> The internal clock mapping is different for each module.
>
> Or we can use one compatible string, but need add another property
> "fsl,asrc-clk-map" to distinguish the different clock map.
>
> The change is in below.
>
> Which one do you think is better?
>
> Required properties:
>
> - - compatible : Contains "fsl,imx35-asrc" or "fsl,imx53-asrc".
> + - compatible : Contains "fsl,imx35-asrc", "fsl,imx53-asrc",
> + "fsl,imx8qm-asrc".
>
> - reg : Offset and length of the register set for the device.
>
> @@ -35,6 +36,11 @@ Required properties:
>
> - fsl,asrc-width : Defines a mutual sample width used by DPCM Back
> Ends.
>
> + - fsl,asrc-clk-map : Defines clock map used in driver. which is required
> + by imx8qm
> + <0> - select the map for asrc0
> + <1> - select the map for asrc1
> +
> Optional properties:
>
I will do a update for this change in v3.
Best regards
Wang shengjiu