2022-03-03 18:02:38

by Adam Ford

Subject: [PATCH 2/2] ARM: dts: logicpd-som-lv: Move pinmuxing to peripheral nodes

Move some pinmux references to their respective peripherals.
This keeps the pins in safe-mode until they are requested.

Signed-off-by: Adam Ford <[email protected]>

diff --git a/arch/arm/boot/dts/logicpd-som-lv.dtsi b/arch/arm/boot/dts/logicpd-som-lv.dtsi
index 55b619c99e24..9ba0ea4eb48a 100644
--- a/arch/arm/boot/dts/logicpd-som-lv.dtsi
+++ b/arch/arm/boot/dts/logicpd-som-lv.dtsi
@@ -27,6 +27,8 @@

/* HS USB Host PHY on PORT 1 */
hsusb2_phy: hsusb2_phy {
+ pinctrl-names = "default";
+ pinctrl-0 = <&hsusb2_reset_pin>;
compatible = "usb-nop-xceiv";
reset-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>; /* gpio_4 */
#phy-cells = <0>;
@@ -144,6 +146,8 @@
};

&usbhshost {
+ pinctrl-names = "default";
+ pinctrl-0 = <&hsusb2_pins>;
port2-mode = "ehci-phy";
};

@@ -151,10 +155,7 @@
phys = <0 &hsusb2_phy>;
};

-
&omap3_pmx_core {
- pinctrl-names = "default";
- pinctrl-0 = <&hsusb2_pins>;

mmc3_pins: pinmux_mm3_pins {
pinctrl-single,pins = <
@@ -250,8 +251,7 @@
};

&omap3_pmx_wkup {
- pinctrl-names = "default";
- pinctrl-0 = <&hsusb2_reset_pin>;
+
hsusb2_reset_pin: pinmux_hsusb1_reset_pin {
pinctrl-single,pins = <
OMAP3_WKUP_IOPAD(0x2a0e, PIN_OUTPUT | MUX_MODE4) /* sys_boot2.gpio_4 */
--
2.17.1

2022-04-21 16:49:13

by Tony Lindgren

Subject: Re: [PATCH 2/2] ARM: dts: logicpd-som-lv: Move pinmuxing to peripheral nodes

* Adam Ford <[email protected]> [220303 19:17]:
> Move some pinmux references to their respective peripherals.
> This keeps the pins in safe-mode until they are requested.

Applying into omap-for-v5.19/dt thanks.

Tony