Currently timeout for autoenumeration during probe and bus reset is set to
2 secs which is really a big value. This can have an adverse effect on
boot time if the slave device is not ready/reset.
This was the case with wcd938x which was not reset yet but we spent 2
secs waiting in the soundwire controller probe. Reduce this time to
1/10 of Hz which should be good enough time to finish autoenumeration
if any slaves are available on the bus.
Reported-by: Srinivasa Rao Mandadapu <[email protected]>
Signed-off-by: Srinivas Kandagatla <[email protected]>
---
Changes since v1:
replaced HZ/10 with 100 as suggested by Pierre
drivers/soundwire/qcom.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/soundwire/qcom.c b/drivers/soundwire/qcom.c
index 7367aa88b8ac..d6111f69d320 100644
--- a/drivers/soundwire/qcom.c
+++ b/drivers/soundwire/qcom.c
@@ -105,7 +105,7 @@
#define SWRM_SPECIAL_CMD_ID 0xF
#define MAX_FREQ_NUM 1
-#define TIMEOUT_MS (2 * HZ)
+#define TIMEOUT_MS 100
#define QCOM_SWRM_MAX_RD_LEN 0x1
#define QCOM_SDW_MAX_PORTS 14
#define DEFAULT_CLK_FREQ 9600000
--
2.21.0
On 06-05-22, 09:47, Srinivas Kandagatla wrote:
> Currently timeout for autoenumeration during probe and bus reset is set to
> 2 secs which is really a big value. This can have an adverse effect on
> boot time if the slave device is not ready/reset.
> This was the case with wcd938x which was not reset yet but we spent 2
> secs waiting in the soundwire controller probe. Reduce this time to
> 1/10 of Hz which should be good enough time to finish autoenumeration
> if any slaves are available on the bus.
Applied, thanks
--
~Vinod