Currently the pin may not be configured as open-drain in some
cases because the argument may be 0 for the boolean types of
the pin configurations. Fix this by ignoring the argument.
With that, allow to actually restore pin to the push-pull mode.
Signed-off-by: Andy Shevchenko <[email protected]>
---
drivers/pinctrl/intel/pinctrl-moorefield.c | 14 ++++++++++++--
1 file changed, 12 insertions(+), 2 deletions(-)
diff --git a/drivers/pinctrl/intel/pinctrl-moorefield.c b/drivers/pinctrl/intel/pinctrl-moorefield.c
index 3c9a8484b442..7656a5e20919 100644
--- a/drivers/pinctrl/intel/pinctrl-moorefield.c
+++ b/drivers/pinctrl/intel/pinctrl-moorefield.c
@@ -661,6 +661,11 @@ static int mofld_config_get(struct pinctrl_dev *pctldev, unsigned int pin,
break;
+ case PIN_CONFIG_DRIVE_PUSH_PULL:
+ if (value & BUFCFG_OD_EN)
+ return -EINVAL;
+ break;
+
case PIN_CONFIG_DRIVE_OPEN_DRAIN:
if (!(value & BUFCFG_OD_EN))
return -EINVAL;
@@ -734,10 +739,14 @@ static int mofld_config_set_pin(struct mofld_pinctrl *mp, unsigned int pin,
break;
+ case PIN_CONFIG_DRIVE_PUSH_PULL:
+ mask |= BUFCFG_OD_EN;
+ bits &= ~BUFCFG_OD_EN;
+ break;
+
case PIN_CONFIG_DRIVE_OPEN_DRAIN:
mask |= BUFCFG_OD_EN;
- if (arg)
- bits |= BUFCFG_OD_EN;
+ bits |= BUFCFG_OD_EN;
break;
case PIN_CONFIG_SLEW_RATE:
@@ -769,6 +778,7 @@ static int mofld_config_set(struct pinctrl_dev *pctldev, unsigned int pin,
case PIN_CONFIG_BIAS_DISABLE:
case PIN_CONFIG_BIAS_PULL_UP:
case PIN_CONFIG_BIAS_PULL_DOWN:
+ case PIN_CONFIG_DRIVE_PUSH_PULL:
case PIN_CONFIG_DRIVE_OPEN_DRAIN:
case PIN_CONFIG_SLEW_RATE:
ret = mofld_config_set_pin(mp, pin, configs[i]);
--
2.40.0.1.gaa8946217a0b
Use explicit comparison to BUFCFG_PINMODE_GPIO instead of implying it.
Signed-off-by: Andy Shevchenko <[email protected]>
---
drivers/pinctrl/intel/pinctrl-moorefield.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/pinctrl/intel/pinctrl-moorefield.c b/drivers/pinctrl/intel/pinctrl-moorefield.c
index 7656a5e20919..2d38d953f360 100644
--- a/drivers/pinctrl/intel/pinctrl-moorefield.c
+++ b/drivers/pinctrl/intel/pinctrl-moorefield.c
@@ -504,7 +504,7 @@ static void mofld_pin_dbg_show(struct pinctrl_dev *pctldev, struct seq_file *s,
}
mode = (value & BUFCFG_PINMODE_MASK) >> BUFCFG_PINMODE_SHIFT;
- if (!mode)
+ if (mode == BUFCFG_PINMODE_GPIO)
seq_puts(s, "GPIO ");
else
seq_printf(s, "mode %d ", mode);
--
2.40.0.1.gaa8946217a0b
On Mon, Jun 05, 2023 at 06:45:22PM +0300, Andy Shevchenko wrote:
> Currently the pin may not be configured as open-drain in some
> cases because the argument may be 0 for the boolean types of
> the pin configurations. Fix this by ignoring the argument.
>
> With that, allow to actually restore pin to the push-pull mode.
>
> Signed-off-by: Andy Shevchenko <[email protected]>
Acked-by: Mika Westerberg <[email protected]>
BTW, looking at the two drivers they seem to have a lot of
commonalities. Perhaps it makes sense to consolidate?
On Mon, Jun 05, 2023 at 06:45:23PM +0300, Andy Shevchenko wrote:
> Use explicit comparison to BUFCFG_PINMODE_GPIO instead of implying it.
>
> Signed-off-by: Andy Shevchenko <[email protected]>
Acked-by: Mika Westerberg <[email protected]>
Tue, Jun 06, 2023 at 08:15:47AM +0300, Mika Westerberg kirjoitti:
> On Mon, Jun 05, 2023 at 06:45:22PM +0300, Andy Shevchenko wrote:
> > Currently the pin may not be configured as open-drain in some
> > cases because the argument may be 0 for the boolean types of
> > the pin configurations. Fix this by ignoring the argument.
> >
> > With that, allow to actually restore pin to the push-pull mode.
> >
> > Signed-off-by: Andy Shevchenko <[email protected]>
>
> Acked-by: Mika Westerberg <[email protected]>
Thank you!
> BTW, looking at the two drivers they seem to have a lot of
> commonalities. Perhaps it makes sense to consolidate?
Yes, that's the plan, perhaps for the next cycle.
--
With Best Regards,
Andy Shevchenko
On Tue, Jun 06, 2023 at 08:15:47AM +0300, Mika Westerberg wrote:
> On Mon, Jun 05, 2023 at 06:45:22PM +0300, Andy Shevchenko wrote:
> > Currently the pin may not be configured as open-drain in some
> > cases because the argument may be 0 for the boolean types of
> > the pin configurations. Fix this by ignoring the argument.
> >
> > With that, allow to actually restore pin to the push-pull mode.
> >
> > Signed-off-by: Andy Shevchenko <[email protected]>
>
> Acked-by: Mika Westerberg <[email protected]>
Both pushed to my review and testing queue, thanks!
--
With Best Regards,
Andy Shevchenko