Oxford Semiconductor PCIe (Tornado) 950 serial port devices need to
operate in the enhanced mode via the EFR register for the Divide-by-M
N/8 baud rate generator prescaler to be used in their native UART mode.
Otherwise the prescaler is fixed at 1 causing grossly incorrect baud
rates to be programmed.
Accessing the EFR register requires 16550A features to have been probed
for, so request this to happen regardless of SERIAL_8250_16550A_VARIANTS
by setting UPF_FULL_PROBE in port flags.
Signed-off-by: Maciej W. Rozycki <[email protected]>
Reported-by: Anders Blomdell <[email protected]>
Fixes: 366f6c955d4d ("serial: 8250: Add proper clock handling for OxSemi PCIe devices")
Cc: [email protected] # v5.19+
---
No change from v1.
---
drivers/tty/serial/8250/8250_pci.c | 5 +++++
1 file changed, 5 insertions(+)
linux-serial-8250-oxsemi-efr.diff
Index: linux-macro/drivers/tty/serial/8250/8250_pci.c
===================================================================
--- linux-macro.orig/drivers/tty/serial/8250/8250_pci.c
+++ linux-macro/drivers/tty/serial/8250/8250_pci.c
@@ -1232,6 +1232,10 @@ static void pci_oxsemi_tornado_set_mctrl
serial8250_do_set_mctrl(port, mctrl);
}
+/*
+ * We require EFR features for clock programming, so set UPF_FULL_PROBE
+ * for full probing regardless of CONFIG_SERIAL_8250_16550A_VARIANTS setting.
+ */
static int pci_oxsemi_tornado_setup(struct serial_private *priv,
const struct pciserial_board *board,
struct uart_8250_port *up, int idx)
@@ -1239,6 +1243,7 @@ static int pci_oxsemi_tornado_setup(stru
struct pci_dev *dev = priv->dev;
if (pci_oxsemi_tornado_p(dev)) {
+ up->port.flags |= UPF_FULL_PROBE;
up->port.get_divisor = pci_oxsemi_tornado_get_divisor;
up->port.set_divisor = pci_oxsemi_tornado_set_divisor;
up->port.set_mctrl = pci_oxsemi_tornado_set_mctrl;