Swapon wastes one page of swap space to no effect.
Mkswap stores the value 'pages - 1' into last_page field, where pages is the
partition size in pages. When nr_good_pages is calculated, last_page + 1
should be used for the number of all the pages header included.
Signed-off-by: Jarkko Lavinen <[email protected]>
---
mm/swapfile.c | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/mm/swapfile.c b/mm/swapfile.c
index 6c0585b..50d90ca 100644
--- a/mm/swapfile.c
+++ b/mm/swapfile.c
@@ -1961,7 +1961,7 @@ SYSCALL_DEFINE2(swapon, const char __user *, specialfile, int, swap_flags)
if (error)
goto bad_swap;
- nr_good_pages = swap_header->info.last_page -
+ nr_good_pages = swap_header->info.last_page + 1 -
swap_header->info.nr_badpages -
1 /* header page */;
--
1.6.5
Cc to Hugh added.
On Wed, Jan 20, 2010 at 05:19:12PM +0200, Jarkko Lavinen wrote:
> Swapon wastes one page of swap space to no effect.
Perhaps this last page newer used problem needs some more explanation.
On x86 example machine A, swap partition is 15631245 kB. /proc/swaps
says the swap space is 15631236 KB, 9 KB less than the partition size
or two page difference. One page for the swap header, and the other
for what ?
On another x86 macine B, swap partition is 409626 KB, /proc/swaps says
it is 409616 KB, 10 KB difference or two pages and alignment bytes.
Again I can understand the need for one header page, but not two.
However swapon system call intends to use all the space available
except the header. This can be seen from swap_map allocation:
SYSCALL_DEFINE2(swapon, ...
...
maxpages = swp_offset(pte_to_swp_entry(
swp_entry_to_pte(swp_entry(0, ~0UL)))) - 1;
if (maxpages > swap_header->info.last_page)
maxpages = swap_header->info.last_page;
p->highest_bit = maxpages - 1;
...
swap_map = vmalloc(maxpages);
This way the swap_map has entries for the whole swap space
except for the header.
Then the nr_good_pages could be calculted with:
- nr_good_pages = swap_header->info.last_page -
- swap_header->info.nr_badpages -
- 1 /* header page */;
+ nr_good_pages = maxpages - swap_header->info.nr_badpages;
This change corrects the last swap file page never used problem.
If the last_page is ever greater than maxpages, this would also avoid
setting nr_good_pages to too large value.
Jarkko Lacinen
On Wed, 20 Jan 2010, Jarkko Lavinen wrote:
> Swapon wastes one page of swap space to no effect.
>
> Mkswap stores the value 'pages - 1' into last_page field, where pages is the
> partition size in pages. When nr_good_pages is calculated, last_page + 1
> should be used for the number of all the pages header included.
>
> Signed-off-by: Jarkko Lavinen <[email protected]>
> ---
> mm/swapfile.c | 2 +-
> 1 files changed, 1 insertions(+), 1 deletions(-)
>
> diff --git a/mm/swapfile.c b/mm/swapfile.c
> index 6c0585b..50d90ca 100644
> --- a/mm/swapfile.c
> +++ b/mm/swapfile.c
> @@ -1961,7 +1961,7 @@ SYSCALL_DEFINE2(swapon, const char __user *, specialfile, int, swap_flags)
> if (error)
> goto bad_swap;
>
> - nr_good_pages = swap_header->info.last_page -
> + nr_good_pages = swap_header->info.last_page + 1 -
> swap_header->info.nr_badpages -
> 1 /* header page */;
>
> --
Sorry to be so slow to respond: I needed to do a little research, and
find time to cool myself down near absolute zero to consider offs-by-one.
You're right that there's an off-by-one there: Nitin and I also noticed
it last year; but I'm afraid I have to Nack your patch, just as I did
Nitin's similar patch last August.
Fixing up nr_good_pages like that makes the numbers displayed look right;
but you're then inconsistent with p->max, counting a page which can never
get to be used.
Here's what I believe is the right patch: is this something you and Nitin
can give your Acks to, or do you see further issues with it?
Thanks,
Hugh
[PATCH] mm: fix swapon size off-by-one
There's an off-by-one disagreement between mkswap and swapon about the
meaning of swap_header last_page: mkswap (in all versions I've looked
at: util-linux-ng and BusyBox and old util-linux; probably as far back
as 1999) consistently means the offset (in page units) of the last page
of the swap area, whereas kernel sys_swapon (as far back as 2.2 and 2.3)
strangely takes it to mean the size (in page units) of the swap area.
This disagreement is the safe way round; but it's worrying people,
and loses us one page of swap.
The fix is not just to add one to nr_good_pages: we need to get maxpages
(the size of the swap_map array) right before that; and though that is an
unsigned long, be careful not to overflow the unsigned int p->max which
later holds it (probably why header uses __u32 last_page instead of size).
Why did we subtract one from the maximum swp_offset to calculate maxpages?
Though it was probably me who made that change in 2.4.10, I don't get it:
and now we should be adding one (without risk of overflow in this case).
Fix the handling of swap_header badpages: it could have overrun the
swap_map when very large swap area used on a more limited architecture.
Remove pre-initializations of swap_header, nr_good_pages and maxpages:
those date from when sys_swapon was supporting other versions of header.
Reported-by: Nitin Gupta <[email protected]>
Reported-by: Jarkko Lavinen <[email protected]>
Signed-off-by: Hugh Dickins <[email protected]>
---
mm/swapfile.c | 31 ++++++++++++++++++-------------
1 file changed, 18 insertions(+), 13 deletions(-)
--- 2.6.33-rc6/mm/swapfile.c 2009-12-18 11:42:55.000000000 +0000
+++ linux/mm/swapfile.c 2010-01-31 13:15:58.000000000 +0000
@@ -1759,11 +1759,11 @@ SYSCALL_DEFINE2(swapon, const char __use
unsigned int type;
int i, prev;
int error;
- union swap_header *swap_header = NULL;
- unsigned int nr_good_pages = 0;
+ union swap_header *swap_header;
+ unsigned int nr_good_pages;
int nr_extents = 0;
sector_t span;
- unsigned long maxpages = 1;
+ unsigned long maxpages;
unsigned long swapfilepages;
unsigned char *swap_map = NULL;
struct page *page = NULL;
@@ -1922,9 +1922,13 @@ SYSCALL_DEFINE2(swapon, const char __use
* swap pte.
*/
maxpages = swp_offset(pte_to_swp_entry(
- swp_entry_to_pte(swp_entry(0, ~0UL)))) - 1;
- if (maxpages > swap_header->info.last_page)
- maxpages = swap_header->info.last_page;
+ swp_entry_to_pte(swp_entry(0, ~0UL)))) + 1;
+ if (maxpages > swap_header->info.last_page) {
+ maxpages = swap_header->info.last_page + 1;
+ /* p->max is an unsigned int: don't overflow it */
+ if ((unsigned int)maxpages == 0)
+ maxpages = UINT_MAX;
+ }
p->highest_bit = maxpages - 1;
error = -EINVAL;
@@ -1948,23 +1952,24 @@ SYSCALL_DEFINE2(swapon, const char __use
}
memset(swap_map, 0, maxpages);
+ nr_good_pages = maxpages - 1; /* omit header page */
+
for (i = 0; i < swap_header->info.nr_badpages; i++) {
- int page_nr = swap_header->info.badpages[i];
- if (page_nr <= 0 || page_nr >= swap_header->info.last_page) {
+ unsigned int page_nr = swap_header->info.badpages[i];
+ if (page_nr == 0 || page_nr > swap_header->info.last_page) {
error = -EINVAL;
goto bad_swap;
}
- swap_map[page_nr] = SWAP_MAP_BAD;
+ if (page_nr < maxpages) {
+ swap_map[page_nr] = SWAP_MAP_BAD;
+ nr_good_pages--;
+ }
}
error = swap_cgroup_swapon(type, maxpages);
if (error)
goto bad_swap;
- nr_good_pages = swap_header->info.last_page -
- swap_header->info.nr_badpages -
- 1 /* header page */;
-
if (nr_good_pages) {
swap_map[0] = SWAP_MAP_BAD;
p->max = maxpages;