On Tue, Mar 26, 2024 at 08:00:04PM +0530, Siddharth Vadapalli wrote:
> On Tue, Mar 26, 2024 at 02:56:26PM +0100, Niklas Cassel wrote:
> > On Tue, Mar 26, 2024 at 04:49:05PM +0530, Siddharth Vadapalli wrote:
> > > In the process of converting .scan_bus() callbacks to .add_bus(), the
> > > ks_pcie_v3_65_scan_bus() function was changed to ks_pcie_v3_65_add_bus().
> > > The .scan_bus() method belonged to ks_pcie_host_ops which was specific
> > > to controller version 3.65a, while the .add_bus() method had been added
> > > to ks_pcie_ops which is shared between the controller versions 3.65a and
> > > 4.90a. Neither the older ks_pcie_v3_65_scan_bus() method, nor the newer
> > > ks_pcie_v3_65_add_bus() method are applicable to the controller version
> > > 4.90a which is present in AM654x SoCs.
> > >
>
> ...
>
> > > + } while (val & DBI_CS2);
> > > +}
> > > +
> > > static int ks_pcie_msi_host_init(struct dw_pcie_rp *pp)
> > > {
> > > + struct dw_pcie *pci = to_dw_pcie_from_pp(pp);
> > > + struct keystone_pcie *ks_pcie = to_keystone_pcie(pci);
> > > +
> > > + /* Configure and set up BAR0 */
> > > + ks_pcie_set_dbi_mode(ks_pcie);
> > > +
> > > + /* Enable BAR0 */
> > > + dw_pcie_writel_dbi(pci, PCI_BASE_ADDRESS_0, 1);
> > > + dw_pcie_writel_dbi(pci, PCI_BASE_ADDRESS_0, SZ_4K - 1);
> > > +
> > > + ks_pcie_clear_dbi_mode(ks_pcie);
> > > +
> > > + /*
> > > + * For BAR0, just setting bus address for inbound writes (MSI) should
> > > + * be sufficient. Use physical address to avoid any conflicts.
> > > + */
> >
> > This comment seems to have wrong indentation.
> > With that fixed:
> >
> > Reviewed-by: Niklas Cassel <[email protected]>
>
> I will fix it and post the v6 patch.
I have posted the v6 patch at:
https://lore.kernel.org/r/[email protected]/
Regards,
Siddharth.